User manual AT&T 905

[. . . ] Plug the free end of the line cord into a modular jack. Plug the coiled cord into the handset jack on the side of the phone. Plug the other end of the coiled cord into the handset, and then hang up. Lift the handset and listen for a dial tone. [. . . ] You can dial or answer calls normally with the ringer off. Other telephones in your home will still ring; they are not affected by the switch. 3 MEMORY Memory Features Capacity: The Big Button Plus 905 telephone can store 12 different telephone numbers, each up to 24 digits long. One-Touch Dialing: Three numbers can be stored in one-touch memory locations. You can dial these numbers by pressing one of the buttons marked with an emergency symbol. Speed Dialing: Nine telephone numbers can be stored in standard speed-dialing locations. You can dial any of these numbers by pressing two buttons. NOTE: You may choose to store emergency numbers in memory locations. This feature is provided only as a convenience and the manufacturer assumes no responsibility for customer reliance upon the memory feature. Programming/testing of emergency numbers should be performed in the early morning or late evening (off peak) hours. Directory Card: Remove the directory card. Write your telephone number in the space provided. Also write the telephone numbers (or names) that you want to store in each memory location. Reinstall the card and clear plastic cover. NOTE: Numbers programmed into a memory location might not be retained if the telephone has been unplugged from the line jack for a half hour or more. One-Touch Dialing Storing Numbers 1 Lift the handset, and listen for a dial tone. 3 Dial the telephone number you want to store. You will hear a beep each time you press a button. 4 Press and release the memory button ( , or ) where you are storing the number. You will hear two beeps to confirm that the number has been stored correctly. 5 Hang up after the number is stored correctly. Repeat Steps 1-5 to store another number in memory. NOTE: Each time you complete storing a telephone number by pressing a memory location, listen for two quick beeps to confirm that the number has been stored in memory. [. . . ] Difficulty Storing Numbers In Memory · Review "One-Touch Dialing" and "Speed Dialing" to make sure you are pressing the correct sequence of buttons. · If you are interrupted by a recorded announcement telling you to hang up (or a loud buzzing noise), hang up and try to enter the number more quickly. · Try calling the number you want to store into memory. When a call is ended, press PROGRAM , REDIAL and a memory button (or press MEMORY and a memory location 1-9). [. . . ]