User manual AT&T 9105

[. . . ] User's Manual for Cordless Telephone 9105 Fold open this manual for information about this telephone's installation and operation. Please read Part 1 -- Important Product Information, included in this package. Part 2 © 1998 Philips Consumer Communications, L. P. 848233458 Issue 1AT&T I N S TA L L AT I O N Changes channel. Handset Volume Control PHONE indicator goes on while you are on a call. [. . . ] To cancel the Handset Locator feature: Press on the handset or press on the base. Changing Channels If you notice interference during a call, press to switch to a clear channel. Special Telephone Services If you subscribe to special local telephone company services like Call Waiting or Call Forwarding, you can access them by pressing whenever you would press the switchhook on a r egular phone. This is like the Flash feature on some other phones. M E M O RY Memory Features This telephone can store 10 telephone numbers, each up to 16 digits long. Numbers will remain stored in memory unless you erase or change them by entering other numbers. Programming a Number into Memory Make sure the handset is . The PHONE indicator will blink to indicate that you are in the programming mode. 3 Enter the phone number (up to 16 digits). 4 Press to store the phone number to the key you selected. The phone now exits mode and emits a tone. NOTE: You may choose to store emergency numbers in memory locations. The manufacturer assumes no responsibility for customer reliance upon this memory featur e. Dialing a Number Stored in Memory: 1 Press to get a dial tone. 3 Press the number button (0-9) you assigned to that phone number. For example, to dial the phone number you assigned to button "6", press , , . IN USE/CHARGE Indicator When the handset is in the base cradle, the IN USE/CHARGE indicator increases intensity with each ring of the incoming call. When the handset is not in the base, the IN USE/CHARGE indicator flashes steadily. After the call is answered, the IN USE/CHARGE indicator will remain lit until the end of the call. Memory Card Memory Card There is a memory card with an erasable surface located on the base to record names or telephone numbers of the numbers stored in memory locations. Programming a Pause Into a Memory Dial Phone Number When programming a number into memory, store the access number and a pause into the number sequence. The pause will allow the switchboard enough time to give you an outside line dial tone. To insert a pause in a stored number, press and hold down the key that comes before the pause, until you hear a second beep. This inserts a 2-second pause after that digit. To insert a longer pause, hold the key down until you hear a third or fourth beep. [. . . ] If you lose a call after changing channels: You were probably almost out of range. Move closer to the base before changing channels. Before placing the call again, set the handset in the base for at least 15 seconds. If the phone does not ring when you receive a call: · Make sure the ringer is turned on. [. . . ]