User manual AT&T 922

[. . . ] User's Manual for the Two-Line Speakerphone 922 Fold open this manual for information about this telephone's installation and operation. Please read Part 1 -- Important Product Information, included in this package. Part 2 © 1998 Philips Consumer Communications, L. P. 848235974 Issue 1AT&T IN CASE OF DIFFICULT Y · Try calling the number you want to enter into memory. When the call is ended, press , and a memory button. [. . . ] After the telephone is plugged in, if you have dial pulse (rotary) service, lift handset and press or , then press or lift handset and press , , , , . To change back to touch tone service, press , , , , . To switch from pulse to tone dialing during a phone call, see "Temporary Tone Dialing. " TELEPHONE OPERAT I O N Making a Call--Handset Press or and then lift the handset. You can dial your call manually or use the memory dialing feature. Answering a Call--Handset Each line has a different ringer tone to signal an incoming call. One of the Line Status lights will flash to identify the ringing line. To answer a call, press the appropriate line button and lift the handset. Making a Call--Speakerphone NOTE: The red speakerphone light will go on when the speakerphone is being used. Wait for a dial tone, then dial the call manually or by using memory dialing. Answering a Call--Speakerphone Press or , and then press . To switch from handset to speakerphone, press . To switch from speakerphone to handset, lift the handset. NOTE: Using an extension phone is not recommended while using the speakerphone. Volume Button The VOLUME button adjusts the speaker or the handset during your call. Adjusting one does not affect the other. When on a call, press to increase volume, to decrease volume. Line Status Lights Whenever a line is in use (at this telephone or any extension), the Line Status light for that line will be on. When a call is put on hold at this phone, the light for the line on hold blinks. NOTE: If the Line Status lights are not working properly, try installing new batteries. Redial The telephone always stores in memory the last number you called. The number (up to 24 digits) will remain in the Redial memory until you dial another number. To dial the same number again, select a line, lift the handset or press , listen for the dial tone , and press . [. . . ] An extension phone "off the hook" can interrupt programming. If you still have trouble, see "In Case of Difficulty. " Dialing Numbers 1 Press or . 2 Lift the handset or press and listen for a dial tone. 4 Dial the telephone number you want to store. [. . . ]