User manual AT&T HS8211

[. . . ] c) Place battery pack in compartment with the wires in the lower left corner, along the bottom of the battery pack. d) Replace cover by sliding it up into place. 3 INSTALLATION 3 Attach the belt clip to the cordless handset (optional). To attach To remove 4 INSTALLATION Table/Desk Installation Standard electrical outlet Modular telephone jack 1 Connect the telephone line cord. Connect the power cord. 2 3 4 5 Charge the handset battery. Charge the battery for at least 24 hours the first time. After the first charge, the battery is typically fully charged overnight. [. . . ] If you move out of range without pressing O, your phone will be left "off the hook. " To hang up properly, walk back into range, periodically pressing O. 11 TELEPHONE MEMORY This cordless phone can store 10 telephone numbers, each up to 16 digits long. You can dial numbers stored in memory just by pressing M and a number button. Store Memory Numbers 1 Make sure the handset is off. 3 Press the number button (0­9) where you want to store the telephone number. 4 Dial the telephone number (up to 16 digits) -- OR -- Press R to store the last number dialed. 5 Press M. Store a Pause in a Memory Number Press to store a two-second pause in the dialing sequence. Each press adds another twosecond pause and counts as one digit. Change/Replace a Stored Memory Number Store a new number in its place. Directory Label Dial Memory Numbers 1 Press P. 2 Press and release M, then press the number button (0­9) where the memory number is stored. Use the selfadhesive directory label to keep a record of the numbers (or names) stored in memory. It's best to write on the label before applying it to the phone. 12 BATTERIES Charging the Handset Battery Pack This battery should remain charged up to six days with the ringer turned on and up to 12 days with the ringer off. A fully charged battery provides an average talk time of about six hours. The battery pack needs charging when: · A new battery is installed in the handset. · The phone beeps twice when you press P. · The phone light flashes slowly. Place the handset in the base so the CHARGING light turns on. The battery pack is typically fully charged in eight hours. You can keep the battery fully charged by returning the handset to the base after each use. If you repeatedly get a low battery indicator, even after eight hours of charging, the battery should be replaced. CAUTION: To reduce the risk of fire or injury to persons or damage to the telephone, read and follow these instructions carefully: · · · Use only Replacement Battery 3301 (SKU# 91076). Do not dispose of the battery in a fire. Check with local codes for special disposal instructions. Released electrolyte is corrosive and may cause damage to the eyes or skin. Exercise care in handling batteries in order not to short the battery with conducting materials such as rings, bracelets, and keys. [. . . ] Put the handset in the base to re-initialize. If you hear a two-beep signal when you try to use the handset: · · You might be out of range. If moving closer to the base doesn't help, try following the directions above for re-initializing the handset and base. If the phone does not ring when you receive a call: · · · · · Make sure the handset ringer is on. Make sure the telephone line cord is connected firmly to the base and the telephone jack. Make sure the AC adapter is plugged firmly into an outlet not controlled by a wall switch. [. . . ]