User manual AT&T TL32100

[. . . ] User's manual TL32100/TL32200/TL32300 DECT 6. 0 cordless telephone/ answering system with caller ID/call waiting Congratulations on purchasing your new AT&T product. Before using this AT&T product, please read Important safety information on page 77 of this user's manual. Please thoroughly read the user's manual for all the feature operations and troubleshooting information you need to install and operate your new AT&T product. You can also visit our website at www. telephones. att. com or call 1 (800) 222-3111. [. . . ] Some service providers bundle or combine multiple services like voicemail and call waiting, so you may not be aware that you have voicemail. To check what services you have and how to access them, contact your telephone service provider. To use your voicemail service rather than your answering system, turn off your answering system. To use your answering system rather than your voicemail service, contact your telephone service provider to deactivate your voicemail service. You can also use your telephone answering system and voicemail together by setting your built-in answering system to answer before voicemail answers as described below. To learn how to program your voicemail settings, contact your telephone service provider. Then, if you are on a call, or if the answering system is busy recording a message and you receive another call, the second caller can leave a voicemail message. If you have voicemail provided by your telephone service provider, we recommend setting your answering system to answer calls at least two rings earlier than your voicemail is set to answer. For example, if your voicemail answers after six rings, set your answering system to answer after four rings. Some voicemail providers may program the delay before answering calls in seconds instead of rings. In this case, allow six seconds per ring when determining the appropriate setting. Answering system new message indication When there are new messages (including memos) on the answering system, the number of new messages stored flashes in the message window on the telephone base and the icon and XX new messages HANDSET 1 appear on the screen of each system handset. If the new 16 new messages message alert tone is turned on, the telephone base beeps every 10 seconds when there are new messages. 10/20 10:30PM To listen to messages recorded on your digital answering system, use the Play messages menu from a handset or press PLAY/STOP on the telephone base (see To listen to messages on page 53). 50 Answering system Answering system overview Voice prompts The system provides voice prompts to guide you through recording announcements and remote access. Message capacity The answering system can record up to 99 messages, depending on the length of each message. Individual messages can be up to the time you set (see Recording time on page 21; individual memos can be up to three minutes), and the approximate recording time is 14 minutes. The actual recording time depends on individual message characteristics. Messages remain available for replay until you delete them. At the beginning of messages playback, if the answering system has less than three minutes of recording time left, the answering system announces, "Less than three minutes to record. " If the memory is full, the answering system announces, "Memory is full. " If the memory is full, the number of messages and F flash alternately in the message window, and Memory full appears on the handset screen. You must delete some messages before recording new ones. Call screening Call screening on the telephone base: If the answering system and call screening are on, the announcement and the incoming message can be heard through the telephone base when a call arrives. You can turn call screening on or off using the handset (see Call screening setup on page 19). [. . . ] If the PRODUCT failure is not covered by this limited warranty, or proof of purchase does not meet the terms of this limited warranty, the manufacturer notifies you and requests that you authorize the cost of repair prior to any further repair activity. You must pay for the cost of repair and return shipping costs for the repair of products that are not covered by this limited warranty. What must you return with the PRODUCT to get warranty service?Return the entire original package and contents including the PRODUCT to the service location along with a description of the malfunction or difficulty; and b. [. . . ]