User manual AT&T TRIMLINE 210

[. . . ] If you cannot hear a dial tone, refer to IN CASE OF DIFFICULTY and try to correct the problem. TO DISCONNECT the telephone, squeeze the clip on the modular plug and pull it out of the jack. 1 WALL INSTALLATION 1 Fill in directory card Remove the directory card and write in your own telephone number. Also write the telephone numbers (or names) that you want to store in each memory location. [. . . ] You can choose from three different ringer tones. 3 Press 3 for Tone 1 ­OR­ Press 6 for Tone 2 ­OR­ Press 9 for Tone 3 ­OR­ Press 0 to temporarily turn off the ringer. Lifting the handset and replacing it onto the base will turn the ringer back on. C D Flash Press F instead of pressing the switchhook to activate custom calling services such as call waiting or 3-way calling. You may have to press other buttons before or after F as explained in custom calling instructions provided by your local telephone company. Figure 1 3 Plug the line cord into the jack on the underside of the base. Feed the line cord into the channel and wind it around the mounting area. Feed the last portion (as short as possible), through one of the slots in the mounting area (Figure 2). Figure 2 Receiver (Handset) Volume Figure 4 The RECEIVER volume switch on the side of the handset can be adjusted for a comfortable listening level. The switch has three volume positions. © 2005 Advanced American Telephones. AT&T and the Globe Design are trademarks of AT&T Corp. , licensed to Advanced American Telephones. Issue 5AT&T 09/05 7 Check for dial tone Lift the handset and listen for dial tone. If you cannot hear a dial tone, refer to IN CASE OF DIFFICULTY and try to correct the problem. 3 4 5 6 2 MEMORY DIALING Memory Features This telephone can store up to 13 different phone numbers, each up to 21 digits long. Numbers will remain stored in memory unless you erase or change them by entering other numbers. NOTE: Numbers programmed into a memory location might not be retained if the telephone has been unplugged from the line jack for a half hour or more. Directory Card: Remove the directory card. Write your telephone number in the space provided. Also write the telephone numbers (or names) that you want to store in each memory location. Reinstall the card and clear plastic cover. MEMORY DIALING One-Touch Dialing Three numbers can be stored in one-touch memory locations . You can dial these numbers by pressing one of the buttons marked with an emergency symbol ( , or ). To program numbers into memory 1 Lift the handset. 3 Press the one-touch memory button where you want to store the number. MEMORY DIALING Speed Dialing Ten telephone numbers can be stored in standard speed-dialing locations. You can dial any of these numbers by pressing two buttons. [. . . ] If it still does not work, try another telephone; if neither telephone works, the problem is not in your telephone. The trouble may be caused by local telephone company lines, central office equipment, or the wiring in your home. 10 PROBLEM You Can Hear the Other Party, but Other Party Can't Hear You SOLUTION · The Mute feature might be activated. · If this doesn't work, try pressing again. [. . . ]