User manual ATIKA ADH 254 A BROCHURE

[. . . ] Do not operate machine before having read the operating instructions, understood all the notes and assembly the machine as described here. Keep the instructions in a safe place for future use. Electrical devices do not go into the domestic rubbish. EC Declaration of Conformity 12 Extent of delivery 12 Characteristics noise values 12 Symbols machine / operating manual 12/13 Normal intended use 13 Residual risks 13 Safe working 13 Before the first start-up 15 Start-up 15 Working with the surface planing and thicknessing 16 machine Maintenance and cleaning 18 Transport 18 Storage 19 Guarantee 19 Maintenance and cleaning schedule 19 Description of device / spare parts 20 Possible faults 20 Technical data 21 Stand Installation tools Fasteners Operating manual After unpacking, check the contents of the box That it is complete Check for possible transport damage Report any damage or missing items to your dealer, supplier or the manufacturer immediately. [. . . ] - Check whether movable parts function perfectly and do not stick or whether parts are damaged. all parts must be correctly installed and fulfil all conditions to ensure perfect operation of the machine. - Damaged guards and parts must be properly repaired or exchanged by a recognized, specialist workshop; insofar as nothing else is stated in the instructions for use. - Damaged or illegible safety labels should be replaced immediately. Do not allow any tool key to be plugged in!Before switching on, check always that wrenches and adjusting tools are removed. Store unused equipment in a dry, locked place out of the reach of children. Extension cable to be designed in compliance with IEC 60 245 (H 07 RN-F) having a core cross-section of at least: - 1. The motor does not reach any longer its maximal power; the function of the device is reduced. Plugs and coupler outlets on connection cables must be made of rubber, non-rigid PVC or other thermoplastic material of same mechanical stability or be covered with this material. protect yourself against an electric shock. Avoid touching earthed parts with your body. the connector of the connection cable must be splashproof. Wind off completely the cable when using a cable drum. Do not use the cable for purposes for which it is not meant. Protect the cable against heat, oil and sharp edges. Do not use the cable to pull the plug from the socket. regularly check the cable and if damaged , have it renewed by a recognised skilled electrician. When running the connection line observe that it does not interfere, is not squeezed, bended and the plug connection does not get wet. Regularly check the extension cables and replace them if they are damaged. Do not use any defective connection cables. Do not set up any provisional electrical connections. [. . . ] remove resin residues from the table plate surfaces. Resin residues can be removed with a commercial maintenance and care spray. apply a thin film of sliding wax on the feed , delivery and thicknessing table plates. Regularly remove resin from the blade shaft and from the parts attached to it. [. . . ]