User manual ATIKA ASP 10 N BROCHURE

[. . . ] Declare under our sole responsibility, that the product Log splitter ASP 10 N to which this declaration relates corresponds to the relevant basic safety and health requirements of the Directive 98/37/EC, and to the requirements for the other relevant Directives: 89/336/EWG, 2006/95/EC. Splitting blade Control arm-left Table plate Motor On / Off-switch Oil tank cap with dip stick Table Wheel Locking lever Control arm-right Control handle Clamping claw left Retaining pin Handle Stroke adjustment rod Holding screw Splitting cross Hydraulic valve Hydraulic oil (1 litre) Safety label 1 Safety label 2 Safety label 3 Safety label 4 Clamping claw right Star grip screw Base Mount control arms Insert control arms and insert pipe in recess of cross connection. Do not operate machine before having read the operating instructions, understood all the notes and assembly the machine as described here. Keep the instructions in a safe place for future use. [. . . ] Plugs and coupler outlets on connection cables must be made of rubber, plasticised PVC or other thermoplastic material of same mechanical stability or be covered with this material. the connector of the connection cable must be splashproof. When running the connection line observe that it does not interfere, is not squeezed, bended and the plug connection does not get wet. Wind off completely the cable when using a cable drum. Do not use the cable for purposes for which it is not meant. Protect the cable against heat, oil and sharp edges. Do not use the cable to pull the plug from the socket. Regularly check the extension cables and replace them if they are damaged. Do not use any defective connection cables. When working outdoors, only use extension cables especially approved and appropriately labelled for outdoor use. Do not set up any provisional electrical connections. never bypass protective devices or deactivate them. The electrical connection or repairs to electrical parts of the machine must be carried out by a certified electrician or one of our customer service points. Local regulations ­ especially regarding protective measures ­ must be observed. Repairs to other parts of the machine must be carried out by the manufacturer or one of his customer service points. Accidents can arise for the user through the use of other spare parts. Ensure that the working area meets the following conditions: - no danger of slipping - level - free of obstacles - sufficiently well lit Do not operate the machine in the direct vicinity of gas or petrol pipes or containers, or any other easily inflammable materials. Before using the log splitter, make sure each time that - there are no faulty connections (tears, cuts, etc. ) Do not use defective power supply cables. - there are no damages at the machine - all screws are tight - check the hydraulic system for any possible leaks - the oil level The transport closure must be replaced by the oil dipstick before start up the machine. Lock in case of power (zero-voltage initiator) The equipment will switch off automatically if there is a power cut. Make sure that the motor turns in the correct direction (see motor arrow), because operation in the wrong direction damages the oil pump. [. . . ] Place a container under the log splitter to catch the old oil. The container should have a capacity of at least 10 litres. Screw off the drain plug to allow the oil to flow out. Check the oil seal and replace it if it is damaged in any way. [. . . ]