User manual ATIKA ASP 4 BROCHURE

[. . . ] Do not operate machine before having read the operating instructions, understood all the notes and assembly the machine as described here. Keep the instructions in a safe place for future use. Never remove a log jammed against the wedge by hand. Before starting any repair, maintenance or cleaning work, always switch off the motor and remove the plug from the socket. [. . . ] The electrical connection or repairs to electrical parts of the machine must be carried out by a certified electrician or one of our customer service points. Local regulations ­ especially regarding protective measures ­ must be observed. Repairs to other parts of the machine must be carried out by the manufacturer or one of his customer service points. Use only original spare parts, accessories and special accessory parts. Accidents can arise for the user through the use of other spare parts. The manufacturer is not liable for any damage or injury resulting from such action. Never try to split logs containing nails, wire or other similar objects. Already split wood and wood chips create a dangerous working area. the operator may stumble , slip or fall. Always keep the working area neat and tidy. Never place the hands on or near any moving parts of the machine when it is switched on. Maintain a safe distance from the log, the ram and the wedge in order to protect your hands from injury. The machine should only be used for splitting logs with a maximum length of 370 mm. Before using the shredder, make sure each time that - there are no faulty connections (tears, cuts, etc. ) - there are no damage at the machine - all screws are tight - check the hydraulic system for any possible leaks Position the log splitter on a work surface at a height of about 60 ­ 75 cm, this will create an comfortable working position. place chocks under the wheels to prevent the machine rolling during operation. Ensure that the working area meets the following conditions: - no danger of slipping - level - free of obstacles - sufficiently well lit Do not operate the machine in the direct vicinity of gas or petrol pipes or containers, or any other easily inflammable materials. Compare the voltage given on the machine model plate e. Only use connection cables with sufficient diameters. Connect the machine via a 30 mA fault current safety switch. Never operate the machine in the event of any possible danger from hydraulic fluid. Ensure that the machine and working area are clean and free of oil. [. . . ] If the oil level is below the lower marking, more oil should be added with the aid of a clean funnel. Log ram Bleed screw Piston rod Dipstick Cylinder cover Check the oil seal and replace it if it is damaged in any way. Replace the dipstick and screw it firmly into place. Do not tighten the screw too tightly, since this may damage the oil seal or the thread in the cylinder cover. [. . . ]