User manual ATIKA ASP 5-520 N

[. . . ] After unpacking, check the contents of the box That it is complete Check for possible transport damage Report any damage or missing items to your dealer, supplier or the manufacturer immediately. Complaints made at a later date will not be acknowledged. 1 ready mounted machine unit 1 operating lever 1 operating manual Do not operate machine before having read the operating instructions, understood all the notes and assembly the machine as described here. Before starting any repair, maintenance or cleaning work, always switch off the motor and remove the plug from the socket. [. . . ] The motor will not be able to provide its maximum performance and the operation of the machine will be impaired. When laying the connecting attachments, be sure that they do get crushed or bent, and that the plug-and-socket connection does not get wet. Do not use the cable for purposes for which it is not meant. Protect the cable against heat, oil and sharp edges. Do not use the cable to pull the plug from the socket. Regularly check the extension cables and replace them if they are damaged. Do not use any defective connection cables. When working outdoors, only use extension cables especially approved and appropriately labelled for outdoor use. Do not set up any provisional electrical connections. never bypass protective devices or deactivate them. The electrical connection or repairs to electrical parts of the machine must be carried out by a certified electrician or one of our customer service points. Local regulations ­ especially regarding protective measures ­ must be observed. Repairs to other parts of the machine must be carried out by the manufacturer or one of his customer service points. Use only original spare parts, accessories and special accessory parts. Accidents can arise for the user through the use of other spare parts. The manufacturer is not liable for any damage or injury resulting from such action. Before using the shredder, make sure each time that - there are no faulty connections (tears, cuts, etc. ) - there are no damage at the machine - all screws are tight - check the hydraulic system for any possible leaks Compare the voltage given on the machine model plate e. Only use connection cables with sufficient diameters. Connect the machine via a 30 mA fault current safety switch. The motor is running as long as the green button remains pushed. A B C D E Log ram Bleed screw Piston rod Dipstick Cylinder cover F G H I J Electric motor Operating pushbutton Splitting wedge Log guide plates Operating lever Do not use any device where the operating pushbutton does not work properly. [. . . ] Always ensure that the splitting wedge and the log ram contact the ends of the log at right-angles. Never try to remove or replace the log during the splitting process. Never try to force the splitting of the log by maintaining the pressure for several seconds. Reposition the log on the main frame and repeat the splitting process, or put the log to one side. [. . . ]