User manual ATIKA ASP 6 N-003 BROCHURE

[. . . ] Declare under our sole responsibility, that the product Log splitter ASP 6 N to which this declaration relates corresponds to the relevant basic safety and health requirements of the Directive 98/37/EC, and to the requirements for the other relevant Directives: 89/336/EWG, 2006/95/EC. Description Splitting blade Control arm-left Splitting table Motor On / Off-switch Oil tank cap with dip stick Wheel Looking hooks Control arm-right Control handle Clamping claw left Retaining pin Handle Stroke adjustment rod Holding screw Splitting cross Hydraulic valve Hydraulic oil (1 litre) Safety label 1 Safety label 2 Safety label 3 Safety label 4 Clamping claw right Star grip screw Mount control arms Insert control arms and insert pipe in recess of cross connection. - Depending on the length of the wood to be cleaved, the table can be mounted at three different heights. - Locking hooks are available in every installation position. [. . . ] longer power supply cables will cause a drop in voltage. The motor will not be able to provide its maximum performance and the operation of the machine will be impaired. Plugs and coupler outlets on connection cables must be made of rubber, plasticised PVC or other thermoplastic material of same mechanical stability or be covered with this material. the connector of the connection cable must be splashproof. When running the connection line observe that it does not interfere, is not squeezed, bended and the plug connection does not get wet. Wind off completely the cable when using a cable drum. Do not use the cable for purposes for which it is not meant. Protect the cable against heat, oil and sharp edges. Do not use the cable to pull the plug from the socket. Regularly check the extension cables and replace them if they are damaged. Do not use any defective connection cables. When working outdoors, only use extension cables especially approved and appropriately labelled for outdoor use. Do not set up any provisional electrical connections. never bypass protective devices or deactivate them. The electrical connection or repairs to electrical parts of the machine must be carried out by a certified electrician or one of our customer service points. Local regulations ­ especially regarding protective measures ­ must be observed. Repairs to other parts of the machine must be carried out by the manufacturer or one of his customer service points. Accidents can arise for the user through the use of other spare parts. Ensure that the working area meets the following conditions: - no danger of slipping - level - free of obstacles - sufficiently well lit Do not operate the machine in the direct vicinity of gas or petrol pipes or containers, or any other easily inflammable materials. Before using the log splitter, make sure each time that - there are no faulty connections (tears, cuts, etc. ) Do not use defective power supply cables. - there are no damages at the machine - all screws are tight - check the hydraulic system for any possible leaks - the oil level - Venting: Vent the hydraulic system before putting the log splitter into operation. [. . . ] Screw off the drain plug to allow the oil to flow out. Check the oil seal and replace it if it is damaged in any way. Dispose of the old oil properly (local oil disposal point). The old oil must not be poured into the ground or drainage system, or mixed with other waste. [. . . ]