User manual ATIKA ASP 8-1050 BROCHURE

[. . . ] After unpacking, check the contents of the box That it is complete Check for possible transport damage Report any damage or missing items to your dealer, supplier or the manufacturer immediately. Complaints made at a later date will not be acknowledged. A ready mounted machine unit B control arm, right and left C Table D operating manual Insert control arms and insert pipe in recess of cross connection (C). Push the retaining pin through before the cross connection (C). [. . . ] When laying the connecting attachments, be sure that they do get crushed or bent, and that the plug-and-socket connection does not get wet. Do not use the cable for purposes for which it is not meant. Protect the cable against heat, oil and sharp edges. Do not use the cable to pull the plug from the socket. Regularly check the extension cables and replace them if they are damaged. Do not use any defective connection cables. When working outdoors, only use extension cables especially approved and appropriately labelled for outdoor use. Do not set up any provisional electrical connections. never bypass protective devices or deactivate them. The electrical connection or repairs to electrical parts of the machine must be carried out by a certified electrician or one of our customer service points. Local regulations ­ especially regarding protective measures ­ must be observed. Repairs to other parts of the machine must be carried out by the manufacturer or one of his customer service points. Use only original spare parts, accessories and special accessory parts. Accidents can arise for the user through the use of other spare parts. The manufacturer is not liable for any damage or injury resulting from such action. To transport the machine, grasp the strap on the splitting column with one hand and tilt the log splitter slightly towards you. The log splitter can be easily transported in this position. Ensure that the working area meets the following conditions: - no danger of slipping - level - free of obstacles - sufficiently well lit Do not operate the machine in the direct vicinity of gas or petrol pipes or containers, or any other easily inflammable materials. Move the splitting blade right down every time before the machine is transported. check that the machine is completely and correctly assembled. Before using the log splitter, make sure each time that - there are no faulty connections (tears, cuts, etc. ) - there are no damage at the machine - all screws are tight - check the hydraulic system for any possible leaks - the oil level 18 Venting: Vent the hydraulic system before putting the log splitter into operation. [. . . ] After longer operating periods, for reduced splitting performance or slight deformation of the cutting edge, grind the splitting blade or sharpen it with a fine file (remove burrs). If the oil level is between the two marking on the dipstick, there is sufficient oil in the reservoir. If the oil level is below the lower marking, more oil should be added with the aid of a clean funnel. Check the oil seal and replace it if it is damaged in any way. [. . . ]