User manual ATIKA BH 800

[. . . ] Extent of delivery Declaration of conformity Description of device / Spare parts Operating times Symbols machine Symbols used in the original instructions Proper use Residual risks Safety instructions Assembly Start-up Working instructions Working with the tiller Maintenance and cleaning Transport Storage Possible faults Technical data Guarantee 8 8 8 8 8 9 9 9 9 11 11 12 12 12 13 13 13 14 14 BH 700 Measured level of the acoustic output LWA Guaranteed level of the acoustic output LWA 92, 3 dB (A) 93 dB (A) BH 800 92, 7 dB (A) 93 dB (A) 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 Denomination Handle Switch handle Safety knob Switch-plug unit Cable strain relief Cable holder Upper handle hoop left Upper handle hoop right Lower handle hoop Body cover Screw M6x45 Washer A6. After unpacking, check the contents of the box > > · Report any damage or missing items to your dealer, supplier or the manufacturer immediately. KG Schinkelstraße 97 59227 Ahlen - Germany herewith declare under our sole responsibility that the product Bodenhacke (Tiller) type BH 700 and BH 800 Serial number: see last page is conform with the above mentioned EC directive as well as with the provisions of the guidelines below: 2004/108/EC, 2000/14/EC. Before initiating the device please observe the provisions pertaining to corresponding laws (regional provisions) for the noise control. [. . . ] Pay attention to sure footing especially when working on slopes or on wet ground and keep your balance at all times. When working on slopes, always work perpendicular to the slope and never up and down. Be especially careful when changing the operating direction on a slope. Observe the safety distance given by the handle bar. Always push the device forward while it is operating. Do not pull it to yourself or behind you. While the motor is running, do not - lift or carry the device about Caution!Do not try to slow down the tool by hand. Pay attention that the blade guard is attached. Turn off the device and wait until the drum has stopped when - tilting the device - crossing hard ground - transporting the device to and from the work area Switch the machine off and remove the mains plug from the socket when - carrying out repair works - maintenance and cleaning - removing malfunctions and blockages - transport and storage - leaving unattended (even during short interruptions) - when the device begins to exhibit unusual vibrations - when you have hit an obstacle with the device. Store unused equipment in a dry, locked place out of the reach of children. Check the machine for possible damage: - Before continuing to use the machine, the protective devices must be inspected to ensure that they work perfectly and with their intended function. - Check whether movable parts function perfectly and do not stick or whether parts are damaged. all parts must be correctly installed and fulfil all conditions to ensure perfect operation. - Damaged guards and parts must be properly repaired or exchanged by a recognized, specialist workshop; insofar as nothing else is stated in the instructions for use. - Damaged or illegible safety warning labels should be replaced immediately. Maintain your device with care: - Ensure that all nuts, bolts and screws are tight. - Make sure that the ventilation apertures are free. Design of the connection cable according to IEC 60245 (H 07 RN-F) with a core cross-profile section of at least - 1. The motor does not reach any longer its maximal power; the function of the device is reduced. Plugs and coupler outlets on connection cables must be made of rubber, non-rigid PVC or other thermoplastic material of same mechanical stability or be covered with this material. the connector of the connection cable must be splash-proof. [. . . ] Clean the device immediately after finishing the work. Clean the bottom of the device and the blade drum. Clean the housing, especially the vent slots, from dirt stuck to it. Do not clean the machine with running water or highpressure cleaners. [. . . ]