User manual ATIKA BIOLINE 2400 BROCHURE

[. . . ] Repairs on electrical parts of the machine and on the safety cut-out must be done by the producer or by a company designated by the producer. Please read the following safety instructions carefully. Within his area of work the operator is responsible for third parties. [. . . ] Do not leave the machine standing in the rain or use when raining. To prevent danger of injury to fingers during assembly or cleaning operations hold the cutting mechanism (for example by means of a wooden wedge, see. Only use extension leads with sufficient diameters: - cable up to 25 metres: diameter at least 1, 5 mm². Before using the shredder, make sure each time that - there are no faulty connections (tears, cuts, etc. Important: Before using the shredder for the first time, close top of case and screw tight. Generally garden shredders require little maintenance. To maintain their efficiency and a long life, observe the following: - After shredding, the machine must be cleaned inside and outside Hedge and tree cuttings, dead flowers and vegetable kitchen waste. Glass, metal, plastic, plastic bags, stones, cloth, roots with soil, food left-overs, fish or meat. special informations on the chopping procedure: · Branches, twigs and wood should be broken down immediately after they have been cut - material of this kinds gets very hard when it is dry, and it therefore makers sense to reduce the maximum branch diameters, so that it is ready for chopping. Remove any side shoots from branches with a large number of twigs. How to chop garden and kitchen waste with hight water content and a tendency to clog - to prevent the machine from clogging, alternate waste with woodcontaining material. Please do not exceed the maximum branch diameter specified for your appliance ( see p. The blades largely pull the material into the machine by themselves. Strong branches may cause overloading. This can be avoided by pulling them back from time to time. If the machine is overloaded, a protective motor switch ensures that the machine turns itself off automatically - turn the shredder on again after about 5 minutes - during those five minutes you cannnot turn the machine, see point 7 , , Operational faults". Please make sure, - that before closing the device, all impurities have been removed from the thread in the housing trough; impurities can block the thread so that the enclosure top of the housing does not close properly motor does not start - that the screw is screwed straight into the housing trough during closing One edge of the knife has become blunt turn knife so that you can use the other edge Both edge of the knives have become blunt replace with new set of knives (order-no. Problem Motor does not start Possible cause - no mains voltage - defective connection cable - enclosure top improperly closed (safety shut-off is activated) - cutters blocked Elimination - check fuse - have it inspected (electrician) - close and bolt down enclosure top correctly, remove any dirt present - switch machine off, disconnect mains plug, and clean interior of machine - have machine repaired by manufacturer or approved company Extension cable at least 1, 5 mm², maximum 25 m long. [. . . ] Subject to alterations due to further development. When conditions in the electrical mains supply are unfavourable, voltage reductions for short periods can occur during the process of turning on the equipment, which can adversely affect other equipment (e. No breakdowns are to be expected if the maximum, electrical mains supply impedances given in the table are met. [. . . ]