User manual ATIKA BIOPLUS 2400 BROCHURE

[. . . ] Please consider the individual country specifications. After unpacking, check the contents of the box That it is complete Check for possible transport damage Report any damage or missing items to your dealer, supplier or the manufacturer immediately. Complaints made at a later date will not be acknowledged. 1 preassembled unit of equipment 1 standing leg (left) 1 standing leg (right) 1 axle 2 wheels 1 screw bag Carefully read operator's manual before handling the machine. [. . . ] Only operate the machine with complete and correctly attached safety equipment and do not alter anything on the machine that could impair the safety. Do not alter the revolution speed of the motor, since this controls the safe maximum operating speed, and protects the motor and all rotating parts against damage due to excess speed. Faulty or damaged parts in the device must be replaced immediately. Close machine properly before enabling motor. Do not spray machine with water (this is hazardous due to live components). Do not leave the machine standing in the rain or use when raining. Store the unused machine in a dry locked place away from the reach of children. Switch the machine off and remove the mains plug from the socket when - carrying out repair works - carrying out servicing and repair works, removal of faults - changing the blades - Transporting - leaving unattended (even during short interruptions) Check the machine for possible damage - Before continuing to use the machine, the protective devices must be inspected to ensure that they work perfectly and with their intended function - Check whether the parts are damaged. All parts must be correctly installed and fulfil all conditions to ensure perfect operation of the saw - Damaged guards and parts must be properly repaired or exchanged by a recognized, specialist workshop; insofar as nothing else is stated in the instructions for use. - Damaged or illegible safety warning labels should be replaced immediately. Design of the connection cable according to IEC 60245 (H 07 RN-F) with a core cross-profile section of at least - 1. 5 mm2 for cable lengths over 25m When laying the connecting attachments, be sure that they do get crushed or bent, and that the plug-and-socket connection does not get wet. Do not use the cable for purposes for which it is not meant. Protect the cable against heat, oil and sharp edges. Do not use the cable to pull the plug from the socket. Regularly check the extension cables and replace them if they are damaged. Do not use any defective connection cables. When working outdoors, only use extension cables especially approved and appropriately labelled for outdoor use. Do not set up any provisional electrical connections. never bypass protective devices or deactivate them. The electrical connection or repairs to electrical parts of the machine must be carried out by a certified electrician or one of our customer service points. Local regulations ­ especially regarding protective measures ­ must be observed. [. . . ] Discretion for the supply of replacements free of charge will remain with the manufacturer. The guarantee does not cover normal wear to: blade, counter blade and impellers, as well as the respectively associated fasteners. All warranty work will be carried out by the manufacturer. The handling of repairs by third parties shall require prior written consent of the manufacturer. [. . . ]