User manual ATIKA FM 2

[. . . ] Complaints made at a later date will not be acknowledged. - Moisture measuring device - Operating instructions Normal intended use · This moisture measuring device is only designed for measuring the moisture content of wood and building materials as well as for measuring the ambient temperature. The moisture content is measured sticking probes into the material to be measured or to hold them on such materials. [. . . ] Take environmental influences into consideration: - Do not use the instrument in a humid or wet environment. - Do not use the instrument in potentially explosive atmospheres where inflammable liquids, gases or dusts are present. - Do not leave the instrument in the rain or use when raining. - Do not expose the instrument to heavy vibrations. - Do not expose the instrument extreme temperatures. Do not allow children to play with this instrument. Keep unused instruments in a dry, locked place out of the reach of children and animals. To exclude the risk of injury always install the protective cap when the instrument is not used. Instrument in "Wood moisture mode" Material from wood such as sawn timber, paper, cardboard Moisture content in % Temperature in degrees Celsius Temperature in degrees Fahrenheit Insert the battery with the correct polarity. To prevent the instrument from getting damaged by a leaking battery remove the battery from the instrument when the instrument is not used for a longer period of time remove used up batteries without delay. Do not short-circuit, charge, open batteries and do not throw them in fire. Keep unused batteries in a dry, locked place out of the reach of children and animals. Working with the moisture measuring device: Powering up Press the key for a short time. Change to the next measuring mode by pressing the key within 3 seconds. Once you have selected your desired measuring mode wait for approx. Note: Firstly measure on dry material and then compare the values with the material to be measured to get a sense for the measured values. To be able to evaluate the moisture distribution within the material measure on different points. Stick both probes into the material (approx. [. . . ] Bring batteries/accumulators, which are no longer usable, to local collecting points or dealers. KG Schinkelstraße 97 ­ 59227 Ahlen - Germany herewith declare under our sole responsibility that the product Moisture measuring device FM 2 is conform with the above mentioned EC directive. - Nu lucrai cu acest aparat în medii unde exist pericol de explozie, în care se afl lichide, gaze sau pulberi inflamabile. [. . . ]