User manual ATIKA GHB 760

[. . . ] You may not start to operate the machine until you have read these operating manual, observed all the instructions given and completely and properly assembled the machine!Keep the instructions in a safe place for future use. contents Extent of delivery EC Declaration of Conformity Symbols - Machine - Operating manual Operating times Normal intended use Risidual risks Safety instructions Assembly Before the first start-up Fuelling - Oil - Oil capacity - Oil filling - Oil level checking - Petrol - Storing fuel (petrol) - Fuelling the garden shredder Start-up - Before starting the engine - Starting the engine - Stopping the engine Working with the garden shredder - What can I shred?- What kind of material can be shredded with the filling hopper and how to feed it ? [. . . ] Always maintain a safe distance (at least 2 m) from walls or other fixed objects. Before each use, check - there are no damages at the machine - All screws are tight. Utmost care is required when handling fuel. Keep away Keep away smoke and open flames (risk of explosion). Clean fresh non-leaded petrol having an octane number of 85 as a minimum. Do not fill in leaded petrol, diesel or other non-approved fuels. Check the oil and fuel level (refill if required). Inspect for damage, replace or repair damaged parts, - check the equipment and tighten loose parts. You must not repair the equipment yourself if you are unauthorized to do so. Grasp and slowly pull the cranking rope handle (22) until you feel a resistance. Pull the cranking rope (23) quickly and then guide it back slowly. Do not fully pull out the cranking rope and do not allow that the rope handle strikes against the engine. Put the choke lever (25) to the position the engine has started. If the engine does not start after the first pulling operation, put the choke lever (25) to the position and repeat the step until the engine starts. Hedge and tree cuttings, bushes, perennial herb, dead flowers No: · Glass, metal, plastic, plastic bags, stones, cloth, roots with soil, food left-overs, fish or meat. What kind of material can be shredded with the filling hopper (1) and how to feed it ?Shrub parts, leaves, organic waste and thin branches can be chopped. Thin and long shrub parts and branches are dragged in rapidly. Process material which contains a lot of water and tends to sticking alternately with woody material to prevent the device from getting blocked. Do not feed too much material at the same time into the filling hopper to prevent the cutting tool from getting blocked. Use a wooden rod to feed hardly accessible material to the cutting tool. This may result in backfire or engine damages. [. . . ] Before each transport: Stop the engine, disconnect the spark plug connector, close the fuel valve and allow the engine to cool down. drain the fuel tank to prevent fuel spilling. Secure the machine within or on the vehicle against getting out of place. Keep unused machines in a dry and closed area out of the reach of children. [. . . ]