User manual ATIKA HB 60

[. . . ] You may not start to operate the machine until you have read these operating manual, observed all the instructions given and completely and properly assembled the machine!Keep the instructions in a safe place for future use. KG Schinkelstraße 97 59227 Ahlen - Germany herewith declare under our sole responsibility that the product Petrol Hedge Trimmer type HB 60 Serial number: see last page is conform with the above mentioned EC directive as well as with the provisions of the guidelines below: 2004/108/EC and 2000/14/EC Following harmonized standards have been applied: EN 774:1996+A1+A2+A3; prEN ISO 10517:2003; EN ISO 14982:1998 Conformity assessment procedure: 2000/14/EC - Appendix V. Measured level of the acoustic output LWA Guaranteed level of the acoustic output LWA 113 dB (A). [. . . ] Outdated fuels and fuel mixtures may result in starting problems. Therefore, mix only that quantity of fuel which you can use within a month. only store fuels in containers approved and identified for this. Keep fuel containers in a dry and safe area. Make sure that fuel containers are kept out of the reach for children. Put the right foot tip in the rear handle. Hold the front handle with your left hand. To make working with the hedge trimmer easier it is possible to choose one of the 5 working positions of the rear handle. When adjusting the throttle lock-out switch (1) can not be pressed. Use your left hand to hold the hedge trimmer on its front handle (13). Turn the handle to your desired position. Make sure that the unlocking device engages again and that the handle is secured. Starting with cold engine Now, you can release the throttle lever and the throttle lock-out switch. Carefully press on the fuel pump (24) several times until fuel comes into the pump. Slowly pull the cranking rope with its handle (11) until you feel a resistance. Pull the cranking rope quickly and then guide it back slowly. Do not fully pull out the cranking rope and do not allow that the cranking handle strikes against the engine. When the engine starts slide the choke (22) to . Carry out the following checks before starting and regularly during working with the hedge trimmer: Is the hedge trimmer assembled completely and properly?Check also that all nuts and screws are tightened. screws on the cutting device: See "Maintenance". Is the hedge trimmer in good and safe condition? [. . . ] If they are loose, tighten them hand-tight. Open the tank cap (10) and pull the fuel filter through the opening using a wire hook. Slight contamination: Pull the fuel filter from the fuel line and clean it in petroleum ether. Clean the hedge trimmer thouroughly after each application so that the faultless function is kept. [. . . ]