User manual ATIKA LSH 2600

[. . . ] Electrical devices do not go into the domestic rubbish. give devices , accessories and packaging to an ecofriendly recycling. According to the European Directive 2002/96/EC on electrical and electronic scrap, electrical devices that are no longer serviceable must be separately collected and brought to a facility for an environmentally compatible recycling. Do not operate machine before having read the original instructions, understood all the notes and assembly the machine as described here. [. . . ] Only operate the machine with complete and correctly attached safety equipment and do not alter anything on the machine that could impair the safety. Faulty or damaged parts in the device must be replaced immediately. Never leave the machine powered when tipping it over on its side. the machine is designed for operating in upright posture. Do not spray machine with water (this is hazardous due to live components). Switch the machine off and remove the mains plug from the socket when - carrying out repair works - carrying out servicing and repair works, removal of faults - checking the leads to see whether these are caught up or damaged - changing over from vacuuming to blowing - transporting - leaving unattended (even during short interruptions) - unusual noises and vibrations Thoroughly maintain your garden vac: - Make sure that the ventilation apertures are free. - Keep handles dry and free of oils and grease. - Follow the maintenance instructions and the instructions for spool exchange. Check the machine for possible damage - Before continuing to use the machine, the protective devices must be inspected to ensure that they work perfectly and with their intended function - Check whether the parts are damaged. all parts must be correctly installed and fulfil all conditions to ensure perfect operation of the saw. - Damaged guards and parts must be properly repaired or exchanged by a recognized, specialist workshop; insofar as nothing else is stated in the instructions for use. - Damaged or illegible safety warning labels should be replaced immediately. Store the unused machine in a dry locked place away from the reach of children. Design of the connection cable according to IEC 60245 (H 07 RN-F) with a core cross-profile section of at least - 1. The motor does not reach any longer its maximal power; the function of the device is reduced. Plugs and coupler outlets on connection cables must be made of rubber, non-rigid PVC or other thermoplastic material of same mechanical stability or be covered with this material. the connector of the connection cable must be splashproof. When running the connection line observe that it does not interfere, is not squeezed, bended and the plug connection does not get wet. Wind off completely the cable when using a cable drum. Do not use the cable for purposes for which it is not meant. Protect the cable against heat, oil and sharp Do not use the cable to pull the plug from the socket. protect yourself against electric shocks. [. . . ] The speed is fully variable from 6000 rpm to 14000 rpm. Do not clean the machine with running water or highpressure cleaners. Do not use solvents for the synthetic parts (petrol, alcohol, etc. Empty the bag every time after it has been used. [. . . ]