User manual ATIKA MHD 2800

[. . . ] Hopper opening for material to be shredded Safety cut-off screw Motor protection On / Off switch Main plug Ventilation apertures Carriage Ejection slot You may not start to operate the machine until you have read these operating instructions, observed all the instructions given and installed the machine as described!Keep the instructions in a safe place for future use. After unpacking, check the contents of the box > > That it is complete Check for possible transport damage Assembly EC Declaration of Conformity Extent of delivery Operating times Symbols on the machine Symbols in the operating manual Proper use Residual risks Safety instructions Commissioning Working with the garden shredder Changing the blades Maintenance and cleaning Guarantee Operational faults Technical data Spare parts 9 10 10 10 10 11 11 11 11 12 13 14 14 15 15 16 124 Report any damage or missing items to your dealer, supplier or the manufacturer immediately. Complaints made at a later date will not be acknowledged. [. . . ] Only operate the machine with complete and correctly attached safety equipment and do not alter anything on the machine that could impair the safety. Do not alter the revolution speed of the motor, since this controls the safe maximum operating speed, and protects the motor and all rotating parts against damage due to excess speed. Do not modify the device or parts of the device respectively. Close machine properly before enabling motor. Take into consideration environmental influences: - Do not use the device in moist or wet ambience. - Do not leave the machine standing in the rain or use when raining. Switch the machine off and remove the mains plug from the socket when - Performing maintenance and cleaning work. - Checking connecting lines, whether these are knotted or damaged. If the machine's filling funnel or ejection slot is blocked switch off the motor and disconnect the mains plug before removing material from the filling funnel or ejection slot. Check the machine for possible damage: - Before further use of the machine the safety devices must be checked carefully for their proper and intended function. - Check whether movable parts function perfectly and do not stick or whether parts are damaged. all parts must be correctly installed and fulfil all conditions to ensure perfect operation of the machine. - Damaged safety devices and parts must be properly repaired or exchanged by a recognized, specialist workshop; insofar as nothing else is stated in the instructions for use. - Damaged or illegible safety labels have to be replaced. Store unused equipment in a dry, locked place out of the reach of children. Design of the connection cable according to IEC 60 245 (H 07 RN-F) with a core cross-section of at least - 1. The motor does not reach any longer its maximal power; the function of the device is reduced. Plugs and coupler outlets on connection cables must be made of rubber, plasticised PVC or other thermoplastic material of same mechanical stability or be covered with this material. the connector of the connection cable must be splash-proof. When running the connection line observe that it does not interfere, is not squeezed, bended and the plug connection does not get wet. Wind off completely the cable when using a cable drum. Do not use the cable for purposes for which it is not meant. [. . . ] Each time before starting maintenance work: - Switch off the motor and pull out the mains plug. Risk of injury to the fingers and hands when carrying out work on the blade unit. The cutters will not come to a standstill immediately after cut-off. Before starting any service work wait until all parts are stationary. [. . . ]