User manual ATLAS DI830-4

[. . . ] 31 2 Contents Additional options . 37 General problems with the dishwasher . 53 Cleaning the drain pump and non-return valve . 59 3 IMPORTANT SAFETY INSTRUCTIONS WARNING ­ When using your dishwasher, follow basic precautions, including the following: Electrical Safety ~ Before installation, make sure that Read all instructions before installation or use of the dishwasher to prevent injury and machine damage. [. . . ] This will enable the temperature in the wash cabinet to settle. Close the door firmly until it clicks into place. 31 Additional options Options With the "Options" button the functions "Turbo" and "Tab" can be selected. ^ Press and hold the "Options" button until the indicator of the desired function lights up. The option will remain active for all programs until the setting is changed again. ^ A program can now be started as usual or the dishwasher can be turned off "V". Tab To achieve the best results, the dishwasher can be programmed for the type of detergent being used. The "Options" button can be used to select between normal detergents (powder or gel ) and tabs. The program sequence is adapted to the selected detergent type. Depending on the program selected the run-time may be extended considerably. If the "Tab" indicator is not lit, the dishwasher is set for normal detergent. If the "Tab" indicator is lit than the program sequence is adapted to suit detergents than contain rinse aid (as well as other components where applicable). The rinse aid dispenser and indicator light are deactivated. The program begins. Additional options Buzzer A signal sounds at the end of a program and when a fault occurs. The buzzer at the end of a program sounds five times in quick succession for up to one hour. The buzzer for a fault sounds in intervals up to two minutes. It can be turned off, so it does not sound at the end of a program. The buzzer for a fault cannot be turned off. ^ Turn the dishwasher off with "o". ^ Press the "Program" button and at the same time turn the dishwasher on with "g". ^ Hold the program button until the lower right program indicator comes on. ^ Press the"Options" button four times. The "Tab" indicator flashes four times in intervals. The time display shows if the program end buzzer is turned on or off. [. . . ] If there is any question concerning the proper electrical connection or grounding of this appliance to the power supply, please consult a licensed electrician or call Miele's Technical Service Department: U 1-800-999-1360 V 1-800-565-6435 Specifications The dishwasher comes equipped with a 4 ft (1. 2 m) power cord with a molded plug for connection to 120 V, 60 Hz, 15 A grounded receptacle. 57 Plumbing Waterproof system All Miele dishwashers have a safety valve located on the incoming water line and a sealed underside with a water sensor. If a fault occurs, the water intake is stopped and the drain pump is activated. Providing the dishwasher was installed correctly by a Miele technician, the waterproof system will protect you from water damage throughout the lifetime of the machine. ­ The water inlet hose comes equipped with a 3/4" female hose thread connector. [. . . ]