User manual ATLINKS TEMPORIS 05

[. . . ] Press 1-9 (1 = 1 second, 2 = 2 seconds, etc. This feature is used to activate customer calling services available through your local phone company, such as Call Waiting. If you subscribe to any of these services, please refer to the phone company's instructions on how to use flash. To answer an incoming call while having a conversation: · After you hear the Call Waiting tone, press and release the flash button. [. . . ] Press options again to store the local area code. When reviewing calls, you may delete all calls by pressing and holding the delete button for more than 4 seconds. When reviewing Caller ID records, you may dialback the phone numbers shown on the display by pressing the dial button. Use the (+) and (-) buttons to scroll to the number you want to dial. 555-1234), then the call was received from within your area code. However, this does not guarantee the call is a local call. 1-234-555-1234), then the call received was not from your area code. Press the dial button, a 10 second timer also starts in the upper right side of the display, letting you know the time remaining until the unit returns to the Summary Screen. If you adjust the number to be dialed, the timer automatically resets itself. To dial the displayed number, pick up the handset before the timer reaches 0. Use the (+) and (-) buttons to display the number you want to dial. See steps 2 through 4 in the above section to complete the dialback sequence. NOTE: IF PICKUP PHONE shows on the display, no other changes to the number can be made. The information sent from the telephone company is known to be a valid number to dial back (available only in limited areas). Once you pickup the phone, the number is automatically dialed. To use this phone, you need an RJ11C type modular telephone jack, which might look like the one pictured here, installed in your home. If you don't have a modular jack, call your local phone company to find out how to get one installed. NOTE: If you make a mistake, you can simply repeat the previous steps until your area code is set. CAUTION: Disconnect the phone cord from the wall outlet before installing or replacing the batteries. Never install telephone wiring during a lightning storm. Never touch non-insulated telephone wires or terminals, unless the telephone line has been disconnected at the network interface. Use caution when installing or modifying telephone lines. [. . . ] NOTE: If you make a mistake, use the delete button to delete wrong digits. Used equipment must be disposed of in compliance with current environmental protection regulations. You should return it to your reseller or dispose of it in an approved recycling centre. The new number replaces the old number at the memory location. [. . . ]