User manual ATLINKS TEMPORIS 06

[. . . ] Connect the other end of the line cord to the wall telephone jack. To install the telephone on the wall, extract the tab (small serrated plastic part) from its housing under the base and reinsert it upside down. Run the line cord through the smaller slot under the base. [. . . ] If this is not suitable, you can switch to pulse dialling by setting the cursor on the side of the handset to DC. This function is only used behind a PBX. Flash time The cursor on the upper side of the handset can be used to modify the flash time (values: 100, 300 or 600 ms). position the cursor on the chosen value. Then confirm the change by hanging up the handset on the base before making a new call. " Check that the line cord is correctly connected to the wall jack. " Check that the ringer is not switched off (see ringer adjustment). You cannot hear your correspondent " Check that another extension on the installation is not being used Caution, never bring your telephone set in contact with water. To clean your set however, you may use a damp cloth. never use solvents (trichlorethylene , acetone , . ) which may damage the plastic surfaces of your telephone set. Never spray cleaning products on your set. During storms, it is advised not to use the set. We would remind you that TEMPORIS 06 is approved in conformity with European regulations, as certified by the marking. Appliance designed for connection to a TRT3 class analogue telephone line (telecommunications network voltage) as defined in standard NF EN 60-950. Thomson Telecom hereby declares that the TEMPORIS 06 appliance is compliant with the essential requirements and other relevant provisions of directive 1999/5/CE. [. . . ] The spare product or part, which may be either new or reconditioned, is guaranteed for a period either of three months from the date of repair, or up to the end of the initial warranty period if this is longer than three months. All parts or products returned and replaced become the property of the manufacturer. However, this warranty becomes null and void in the following cases: Installation or use other than as instructed in this guide; incorrect connection or abnormal use of the product, in particular with accessories not specifically recommended; products which have been knocked or dropped ; products damaged by lightning, voltage surge, source of heat or radiation, water damage, exposure to excessive humidity, or any other cause outside the product itself; defective maintenance, negligence; maintenance, modification or repair by a person not approved by the manufacturer or reseller. [. . . ]