User manual AUDIO DESIGN HFI200A MKII

[. . . ] Protect the device from moisture and humidity. ⷠEnsure that your subwoofer enclosure will not get loose during the drive and hurt someone in the passenger cabin. It is recommended, that you mount the subwoofer enclosure with suitable belts or any other mounting solutions in the trunk area. [. . . ] BEFORE THE CONNECTION For the professional installation of a sound system appropriate wiring kits are available in car audio retailer stores. Attend the sufficient profile section (at least 10 mm2), the suitable fuse rating and the conductivity of the cables when you purchase your wiring kit. Clean and remove ruststreaked and oxidized areas on the contact points of the battery and the ground connection. Make sure that all screws are fixed tight after the installation, because loosely connections may cause malfunctions, unsufficient power supply or interferences. GND Connect this GROUND terminal with a suitable contact ground point on the vehicle's chassis. The ground wire must be as short as possible and must be connected to a blank metallic point at the vehicle's chassis. Ensure that this ground point has a stable and safe electric connection to the negative "­"pole of the battery. Check this ground wire from the battery to the ground point if possible and enforce it, if required. Use a ground wire with a sufficient cross section (at least 10 mm2) and the same size like the plus (+12V) power supply wire. Automatic antenna) or the turn-on remote signal of your headunit with the REM-terminal of the amplifier. Use therefor a suitable cable with a sufficient cross section (0, 5 mm2). Thereby the amplifier will turn on or off automatically with your headunit. Use therefor a suitable cable with a sufficient cross section (min. 10 mm2) and install a additional in-line fuse. For safety reasons the distance between the fuseblock and the battery must be shorter than 30 cm. Do not install the fuse into the fuseblock until the installation is accomplished. [. . . ] The remote turn-on connection from the headunit to the amplifier is not correct. In case of replacing the fuses, attend by any means the correct fuse rating. Malfunction: no signal is audible, but power LED lights up Remedy: Turn down the level Turn down the level on the headunit Switch off loudness on the headunit Reset bass EQ on headunit or amp Overloaded by insufficient power supply (too thin profile section on the power cables). [. . . ]