User manual AUDIO TELEX PAGENET88

[. . . ] To use the PN88M, just select the zones you wish to page and press and hold the 'Zone Page' button. [. . . ] A busy LED will flash on all of the other paging mics while the 'Zone Page' button or 'All-Page' button is held. If you wish to make a page and see that the 'system Busy, LED is flashing, it means that somebody else is paging and that you should wait until they have finished 6ight wili extinguisl) before you use your microphone. Microphones I and 2 can page irrespective or whether the system is busy oi not, howevei they will mute anybody at a lower priority level. As a general rule, the busy LED shouldn't be igrrored unless the page is urgent. The PN88M has a balanced XLR line level output, as well as two 15 pin 'D Sub' connectors. The 4tr dip switch position is a bass roll-offswitch for instances where the microphone is 'boomy', perhaps because of a lot of bass boost on the matrix. hg, 'ilet 8slVl @ rnmiorr{Fr PN88M Paging Microphone HHHH HHFH o . H. ^F_ Ii!"r H lmportant!! Please note that each zone microphone must have it's address (to identify it as mic 1-8) set via the dip switches on the bottom of the mic base. Each mic must then be plugged into the corresponding XLR and 15 pin 'D' inputs on the metrix. When microphones are 'daisy-chained' then the 15 pin connector needs to be plugged in to the matrix input which matches the mic that is directly on the other end of that cable. [. . . ] For example, lets say Mic's 3, 4 and 5 are'daisy-chained. '. [. . . ]