User manual AUDIO TELEX TX6000

[. . . ] Featuring six dual purpose inputs consisting of XLR balanced mic inputs and dual RCA aux/line level inputs. Channel 6 has a highr aux/line level input sensitivity to enable it to accept a CD player or similar high level input sigrral. Front Panel Controls O oiQiA , Pi Qi ', cc o ooooooo N0l0 Tttil o jj jjj -X- rxsooo O OE l. Dual ilicrophone/Line Gain Gontrols: The 6 dual mic/line input contols are marked Ch strould be adjusted to provide the required mix level for each individual channel. [. . . ] 8 @ @ @88@ @ AA A IA lnlet VA. 3 Pin IEC AC Mains Power amp slow blow fuse plus one spare. Power consumptior is 15 disconnected before attempting to check or rcplace this fuse. The operating voltage is 240 VAC @ 50 Hzor I l0 VAC @ 60tuz. The AC power voltage is not externally user adjustable but is factory preset. The inlet is equippedwith an inbuilt AC fus; holder fitted with a 0. 5 thst the mains power cord is 24 Volts DC Power Source Connection: 2. lmm VD. C battery for applications where PA systern operation is imperative. The centre terminal post or pin is for connection to the positive (+) tenninal. The sleeve is for connection to the negative (-) terminal. DC power socket allows for the connection of an exrernal 24 Spare SCrew Tgfminalsl These spare screw terrninals allow the connection of various optiural tone module accessories. They are not connected to any point in the mixer from the factory and are spare. 4. Suitable for driving power amplifiers or similar devices. Pin 3 = Active Negative O. 5. !-ilp_Ogtput ude XLR style active balanced isolated output for connection to a power amplifier. l. sv RMS output. provides I : Earth. pin 2 = Active a maximum of IfpC OUtput 2 x RCA style phono output connector for line level output. Provides a maximurn of 700mV into loK Ohms, ideal for a connection to most ttrydutd tape recorders. This outptd is sourced before the master gain contol and as sudr the tape output level is not influenced by the operation of the master gain contol. MiCfOphOne lnputsl Note: All inputs are universal line / microphone inputs Both connectors can not be utilised for any one input channel. Six fernale XLR inputs accept 200 Ohm balanced or rmbalanced microphone inputs. pin 3 Active Negative O. : : 7. Line lnpUts: Note: All inputs are universal line / microphone inputs. Both connectors can not be utilised for any one input channel. [. . . ] Provides single muting frorn channel I only. When activated all other channels are muted. TX30l4MutingModule-Providesdualprionitymuting. [. . . ]