User manual AUDIOBAHN ABC6002Q

[. . . ] Judge for yourself, and remember what it's all about, "If it's not Bigger, Badder & Better, it's not Audiobahn. " If audio is your life, Audiobahn is the brand for you!People never stop trying to get the best product, so we will never stop making it. *To learn more about "TEAM AUDIOBAHN" please give us a call, see our website at website at www. audiobahninc. com, or email us at team@audiobahninc. com to learn about all the details. Table of Contents Getting Started----------------------------------------------------- 2 Introduction---------------------------------------------------------- 3 Features and Specifications------------------------------------- 4 Mounting and Setup------------------------------------------------ 5-8 Choosing a Location----------------------------------------------- 9 Installation------------------------------------------------------------ 10 Wiring------------------------------------------------------------------ 11 Securing the Speaker---------------------------------------------- 12 Troubleshooting------------------------------------------------------13 Warning and Disclaimer------------------------------------------- 14 Warranty---------------------------------------------------------------15-16 Getting Started Welcome to Audiobahn Inc. . This manual has been designed to provide information for the owner, salesperson, and installer. For those of you who want quick information on how to install this product, please turn to the installation section of this manual. [. . . ] This will allow a test of the speaker before securing it to its permanent location. Caution: Make sure that all speaker wiring is fully protected from cuts, tears and possible wear. All short circuits developing as a result could severely damage the source unit or possibly the amplifier as well as the speakers themselves. Makes sure all speaker wires are placed easily within reach of the speaker terminal with no stress on the wire or connectors. Mounting 1) Confirm the mounting location and depth requirements by inspecting the area where the speaker will be mounted. Most speakers will fit into stock locations on the vehicle. In this case only depth consideration is important. 2) If the location you have picked does require cutting, you may use the supplied template to help you locate and mark the mounting location and cuts to be made. Be careful when cutting out the template. If you cut the template properly, the speaker will be a perfect fit. 3) If there is a cosmetic panel where the speaker will be mounted, we recommend using a utility knife to carefully cut a hole in it. Confirm the cut by placing the speaker in the hole. You may need to modify the hole cut as necessary. 4) If it is necessary to cut steel, reinstall the cosmetic panel in place and use the hole you have previously cut as a template. This will help to insure proper cutting and a good fit. Mark the locations for the speaker mounting screws. Then remove the panel and drill the screw holes. When finished you can replace the panel. 5) After cutting and drilling all holes, inspect the mounting areas for any metal burrs or rough edges. File any area that may interfere with the mounting of the speaker. 6) Clean any metal shavings from the mounting area and check for areas in which water may enter the speaker cavity. Treat the area for water protection when necessary. Make sure your source unit (Cassette, CD, DAT, DVD etc. ) is turned off while connecting the speaker terminals. [. . . ] If you are having problems with your system, we recommend you check the product carefully and thoroughly to confirm that the product truly has a manufacturer defect; as opposed to abuse, or other components in the system causing the failure. This might include having an Authorized Audiobahn Dealer look at the product to confirm the source of the problem. Any product found to have a manufacturer defect will be replaced with a new piece of the same or similar model, or repaired at the discretion of Audiobahn. Any product found to have no manufacturer defect will be returned to the sender at their cost. [. . . ]