User manual AUDIOLINE AB 880

[. . . ] Connecting the telephone line and power adapter plug . Dialling a phone number from the calls list . Deleting a phone number from the calls list . Under no circumstances open the device or complete any repair work yourself. [. . . ] Press the button while the outgoing message is being played back. The next time a call is received, the answering machine plays the default outgoing message. Setting the number of rings on the rear side of the answering machine is a sliding switch (2 6 TS). Set the sliding switch to the number of times the answering machine should ring before it takes a call. Position 2 6 TS The call is taken after two rings. The first call is taken after six rings and all the other calls after two rings. This switch position can be used to implement the toll-saving remote access function. This switch is used to set the length of time for a recorded message. You can select between 60 or 120 seconds. If the caller speaks for a longer period, an acoustic signal is issued and the call is disconnected. If there is a pause in excess of seven seconds during recording, the call is automatically ended, accompanied by an acoustic signal. The answering machine is switched on, the LED above the q/p button lights up. The integrated loudspeaker enables you to listen to messages as they are being recorded. If you do not want to listen-in to incoming calls, reduce the volume by pressing the Volume button z as often as necessary. If you lift the receiver while an incoming message is being recorded, recording is stopped and you can talk to the caller. When the LED above the q/p button is flashing, it means that new messages, memos or call extracts have been recorded in your absence. The new message recorded is played back first. If the LED is not flashing, all recorded messages that you have not yet deleted will be played back. If no messages have been saved, you will hear several beep tones. After the last message has been played back, two acoustic signals are issued. Press the REC/x button until the previous message is played back again. Press the u/CHECK button once to skip the message currently being played. [. . . ] Every 30 seconds you will hear two beep tones. If you want to continue listening, press the 0 and # button again within 10 seconds, otherwise the connection will be automatically terminated. If there is no memory left for new messages, the answering machine will no longer accept calls. You will hear an announcement of SPEICHER VOLL". [. . . ]