User manual AUDIOLINE TAB968

[. . . ] 44 Deleting individual numbers from the phone book. 47 Dialling a telephone number directly from the caller list . 47 Storing telephone numbers from the caller list in the phone book . 48 Deleting telephone numbers from the caller list . [. . . ] Now press and hold the button again for 2 seconds until the message ALLE GELOESCHT appears in the display. Using caller display, you can see in the case of incoming calls who is calling you. If this function is available on your line, the display shows you the caller's telephone number while the telephone is ringing. The display reports the following information when there is no telephone number available. If the message KEINE NUMMER appears in the display, the number has only been partially or incorrectly received. If the message PRIVAT appears in the display, the caller has suppressed the transmission of his telephone number or it was not possible to transmit the number. Your telephone will show the number in the display if your telephone provider offers this service. Please ask your telephone provider for further information. If this service is not available, incoming calls will not be shown in the display. In your absence, all calls will be saved in a caller list with date and time. up to 99 numbers are saved in the caller list. When the list is full, the oldest number is always deleted from the list. If calls are registered during your absence, this will be indicated in the display by the message NEU and the indicator light for new calls will flash. Note: The new calls display is not dependent on the calls recorded on the answering machine. Calls will also be stored in the caller list even where no message has been left on the answering machine. Number of all new entires in the caller list You can page through the caller list using the Jogdial. The call is new The caller called several times Name of the caller, if stored in the phone book When all newly recorded numbers have been checked, the new call indicator light goes off and the NEW indicator in the display shows "0". If no button is pressed within 30 seconds, the caller list is no longer displayed and the display shows the current time and date once more along with the number of telephone numbers stored in the caller list and the number of newly stored telephone numbers. Dialling a telephone number directly from the caller list You can dial telephone numbers directly from the caller list. If you want to change to using the receiver, simply lift the receiver. Before dialling, your telephone compares the country and local dialling codes of the number selected with your location (country + local dialling code). If you have entered your country and local dialling code during installation, the appropriate numbers will not be dialled if this is a number from within your country or local network. [. . . ] Of course, you can always ring your network operator's service department, which will give you more advice on checking your installation. 2 Answering machine The answering machine cannot be switched on Check whether the mains adapter has been properly plugged into the mains socket and that the mains adapter cable is properly seated at the rear of the telephone. Check whether there is power at the mains socket. Battery monitoring light flashes The batteries are flat and must be changed. [. . . ]