User manual AUDIOLINE TAM809

[. . . ] Press and release the [TIME SET] button repeatedly to set the day. Press and release the [TIME CHECK] button to confirm setting. Repeat the two points above to set Hours, Minutes an AM/PM settings. Press and release the [TIME CHECK] button to store settings. [. . . ] To turn the speaker up, repeatedly press the · volume button. INTERCEPTING MESSAGES # If, while listening to a message being recorded you decide to answer a call, lift the handset on a telephone connected to the same telephone line. # If recording continues, press [STOP] on the TAM809, or # on the telephone you are using. 3 USING THE ANSWERING MACHINE AUDIOLINE TAM809 MEMO RECORDING (NOTE PAD FACILITY) # With the unit switched on, press and hold the [MEMO] button. # After a beep the green light will flash, record your message. # When finished, release the [MEMO] button. NOTE: The message light flash rate will increase if a memo has been recorded. VOICE-CONTROL # The unit will record for as long as the caller speaks, up to the maximum time of 60 seconds per message. If a caller stops talking, the unit will disconnect the line after approximately 7 seconds. 2-WAY RECORDING (RECORDING A CONVERSATION) # Press and hold the [TWO WAY] button until a beep is heard (usually 3 seconds. ) # The green light will begin to flash, release the [TWO WAY] button. # Press the [TWO WAY] button again to stop recording. Warning: If you do not press the [TWO WAY] button to stop the recording, the unit will continue to record, until the recording memory is full. NOTE: The green light flashes rapidly while recording, and a beep will be heard approximately every 15 seconds during any two way recording. IF MEMORY IS FULL # The total recording capacity is up to 11 minutes maximum. # The unit will answer calls after 16 rings and emit one long beep (no new messages will be recorded at this time). The green light will flash, 2 seconds on, 2 seconds off to indicate memory full. # It is still possible to access the unit by remote control, by entering the remote code after the long beep. It is recommended that messages are played and then deleted (manually or by remote) to make space for new messages. POWER FAILURE # During a power failure, the unit cannot receive incoming messages. # Existing messages will be saved (for up to 24 hours maximum) if a good quality Alkaline battery is installed. 4 AUDIOLINE TAM809 USING THE ANSWERING MACHINE REMOTE CODE # A three digit code is located on the bottom of the unit. Please make a note of this and keep it in a safe place. SWITCHING ON REMOTELY If you did not turn your TAM809 on prior to leaving home, you can do so remotely: # Call your home telephone number. # After 16 rings the machine will answer and a tone will be heard # Enter the 3-digit remote code. # One short beep will be heard, enter 9 # and the unit will switch on. If the answering machine does not respond, redial and press each digit for slightly longer. NOTE: The power supply must be connected and the power/unit switched on. REMOTE FUNCTIONS # Call your home telephone number. # During the OGM, enter your 3-digit remote code. # One short beep will be heard, you can then. [. . . ] # Do not use abrasives, solvents or spray polish that may enter through holes in the cabinet and cause damage. # Do not place the telephone answering machine in direct sunlight or use in extreme humidity. GUARANTEE If you believe your TAM809 is malfunctioning, please refer to the relevant section and/or consult the troubleshooting guide in this manual to ensure that you have followed the instructions carefully. The TAM809 is guaranteed for a period of 12 months from the date of purchase. In the unlikely event of a fault during this period, please contact us for assistance. [. . . ]