User manual AUDIOLINE TEL28

[. . . ] 26 Saving numbers under the speed dial buttons . 26 Making a call using the direct dial buttons. 27 Making a call using the speed dial buttons . 28 Dialling and storing telephone numbers when using on private exchanges . [. . . ] When using T-NET functions, move the slide switch on the underside to the "300ms" position. Your telephone is also suitable for wall mounting. Drill two holes horizontally side by side, 70 mm apart, and leave the screws protruding from the wall by 5mm. Now place the telephone without the desk support over the screws and push it slightly downwards. There is a small hanging device in the receiver rest to prevent the receiver from falling when it is placed on the rest with the telephone mounted on the wall. Using a small screwdriver, turn this hanging device until a small hook appears at the upper end. If you are using the telephone fitted to the wall, you can hang the receiver on the telephone without hanging up. You will find a small hook for this purpose at the upper end of the receiver rest. If you want to reset the time or change a time already entered, proceed as follows: 1. Button several times or keep the button pressed until the Press the correct number of hours appears in the display. Press the button several times or keep the button pressed until the correct number of minutes appears in the display. The current time of day is started by pressing the Replace the receiver. Note: If the battery is completely discharged, it will be necessary to re-enter the time of day. Making a call using the receiver or handsfree feature The AUDIOLINE TEL28 telephone can be used like any conventional telephone and, in addition, has some useful special features, which make phoning considerably easier for you. You have two ways of making a call: A: Making a call using the receiver 1. Lift the receiver and wait until you hear a dialling tone. The display can show a telephone number with a maximum of 12 digits. If the number dialled is longer than this, only the last 12 digits will be displayed. If the receiver volume is too quiet or too loud, you can change this to suit your requirements. If you want to change during a call from the receiver to the handsfree facility, press the button and replace the receiver on the rest. The LED above the button will come on and you will hear the dialling tone from the in-built loudspeaker. The display can show a telephone number with a maximum of 12 digits. [. . . ] Making a call using the direct dial buttons The stored number will now be dialled automatically. To end the call, replace the receiver or press the handsfree button once more. Making a call using the speed dial buttons Now press the required storage location between 0 and 9 on the keypad. The stored number will now be dialled automatically. [. . . ]