User manual AUDIOLINE TEL49 CLIP

[. . . ] 4 Dialling using the speed dial buttons . 31 Dialling telephone numbers when using on private exchanges . 33 Dialling a telephone number directly from the Caller List. If you should have any questions, please contact our Service Department on the Hotline number 0180 5 00 13 88. [. . . ] This completes the entries and the current Confirm with the data will now be shown in the display. If the batteries are fully discharged, the time and date must be re-entered. - Setting up Note: If you ever have to change the local or national dialling code at a later date, start programming by pressing the keys simultaneously. You can move the flashing cursor to the desired position by means of the delete button . You can now change the selected number with the buttons. In order to delete a number altogether, enter a minus sign (-) using the buttons. 8 Setting the display contrast If the display cannot be seen clearly, you can adjust the display contrast to suit the lighting conditions. The display contrast can be adjusted in three steps by means of the "CONTRAST" slide switch on the right-hand side. 9 Private exchanges - T-NET set-up You can use the "R" signal button on your telephone on private exchanges and when using DEUTSCHE TELEKOM's T-Net functions. If you use neither a private exchange or the T-NET-functions of the DEUTSCHE TELEKOM, no adjustments must be made here. Private exchanges If you have connected your telephone to a private exchange, you can use all the facilities such as call transfer, automatic recall, etc. The "R" signal button gives you access to these facilities. the FLASH time "100ms" (factory setting) will be required on a private exchange. To make this setting, move the slide switch on the right side to the "100ms" position. You can find out from the dealer from whom the equipment was purchased whether your telephone will work on your private exchange without any problems and which other facilities you will have access to. Please contact DEUTSCHE TELEKOM to gain access to these functions (some of which are subject to charge). When using T-NET functions, move the slide switch on the right side to the "300ms" position. 1 Using the telephone Your telephone can be used like any conventional telephone. PLEASE FOLLOW THE INSTRUCTIONS: Lift the receiver and wait until you hear the dialling tone. Shows the Now dial the required telephone number. the number dialled will be shown in the display. The display shows a telephone number with a maximum of 16 digits. [. . . ] Select the telephone number that you want to delete from the caller list using the buttons. Now press the button twice and the number will be deleted. Select one telephone number from the caller list using the 2. 1 Fault Finding Remove all extra telephone equipment and connect only the telephone directly to the telephone socket. [. . . ]