User manual AUDIOLINE TEL4CLIP

[. . . ] Then feed the cable through the cable guide and away from the telephone either to the top or to the bottom. Drill two holes 83 mm apart and leave the screws protruding 5 mm from the wall. Now place the telephone over the screws and push down slightly. When the telephone is used on a table, the receiver hanging hook must be in the flush position as shown in diagram A (factory setting). [. . . ] If a storage location has already been used, the display shows the message "OVERWRITE". The selected storage location is overwritten with the new telephone number by means of the button. If you do not want to overwrite the storage location, press one of the buttons cancel the entry. Note: Storage locations 01, 02 and 03 are dialled using the direct dial buttons M1, M2 and M3. Press the speed dial button and the required storage location from 01 to 18 on the number pad. Your telephone will show the number in the display if your telephone provider offers this service. Please ask your telephone provider for further information. If this service is not available, incoming calls will not be shown in the display. Using caller display, you can see with incoming calls who is calling you. If this function is available on your line, the display shows you the caller's telephone number while the telephone is ringing. If the call is not accepted, this indication remains in the display for 60 seconds before the current time and date are shown once more. Furthermore, in your absence, all calls are saved in a caller list with date and time. up to 99 numbers are saved in the caller list. When the list is full, the oldest number is always deleted from the list. If calls are registered during your absence, the "NEW CALL" LED flashes and the display shows the number of newly stored numbers (XX NEW). The total number of telephone numbers stored in the caller list is also displayed (XX CALLS). You can find out how to view the list in the next chapter 4. 1 VIEWING THE CALLER LIST and You can page through the caller list using the buttons. You can see the latest numbers by means of the button whereas you can view the numbers that have been stored for some time by using the button. When you reach the last storage location the display shows the message "End of list". The number of the currently selected storage location between 1 and 99 appears under "CALL #" in the display. If a caller has tried to reach you several times, the message "RPT" appears in the display and beneath it the number of calls. [. . . ] Exchanged parts or exchanged equipment become our property. Claims for compensation are excluded insofar as they do not relate to criminal intent or gross negligence on the part of the manufacturer. All guarantee claims according to these conditions must be raised exclusively with your dealer. Rights under the guarantee can no longer be enforced after the expiry of 24 months from purchase and delivery of our products. [. . . ]