User manual AUDIOLINE TEL5

[. . . ] You can find out from the dealer from whom the equipment was purchased whether your telephone will work on your private exchange without any problems. Due to the large number of different private exchanges, it is not possible to guarantee this function. Temperature and Ambient Conditions The telephone is designed for use in protected rooms with a temperature range of 10 °C to 30 °C. The base station must not be installed in damp rooms such as a bathroom or laundry room. [. . . ] Drill two holes 85 mm apart, vertically one above the other, and leave the screws protruding 5 mm from the wall. Now place the telephone base over the screws and push down slightly. When the telephone is mounted on a wall, you can hang the receiver on the telephone without cutting off the call. A small hook is located at the top of the receiver rest for this purpose. Making a call Your telephone can be used like any conventional telephone. Please follow the instructions: Lift the receiver and wait until you hear the dialling tone. to end the call , replace the receiver on the rest. You can end the current call by using the disconnect button and you will immediately obtain a new dialling tone. When a call comes through, you will hear the ringing tone. The call can now be accepted using the receiver. If the receiver volume is too quiet or too loud for you, you can change this to suit your requirements. You can adjust the volume from soft to loud using the VOL. If a connection that you have dialled is engaged or you were unable to get through to anybody, simply replace the receiver. The last number dialled remains stored in the telephone automatically. To use the redial facility, proceed as follows: Lift the receiver and press the redial button redial number will now be dialled. By means of the slide switch on the receiver you can (loud) or (soft) to match the volume choose the settings of the ringing tone to your requirements. If at any time you do not want to be disturbed, use the setting (off). You can use the "R" signal button on your telephone on private exchanges and when using DEUTSCHE TELEKOM's T-Net functions. If you have connected your telephone to a private exchange, you can use all the facilities such as call transfer, automatic recall, etc. The "R" signal button gives you access to these facilities. You can find out from the dealer from whom the equipment was purchased whether your telephone will work on your private exchange without any problems and what further facilities you will receive from this. Dialling telephone numbers when using on private exchanges With private exchanges, it is necessary to dial a certain number (e. [. . . ] Exchanged parts or exchanged equipment become our property. Claims for compensation are excluded insofar as they do not relate to criminal intent or gross negligence on the part of the manufacturer. All guarantee claims according to these conditions must be raised exclusively with your dealer. Rights under the guarantee can no longer be enforced after the expiry of 24 months from purchase and delivery of our products. [. . . ]