User manual AUDIOLINE VR-C10

[. . . ] The following parts will be found in the package: VoiceRecorder with 2 x batteries Operating manual 2 x batteries type AAA audio cable earphone Slide the battery cover on the rear to the right using slight pressure and open the battery compartment. Now insert the two batteries taking care to ensure that the polarity is correct. The wrong polarity can damage both the batteries and the unit. Never change the batteries during a recording, as otherwise a complete loss of data can occur. [. . . ] Switching VOS on or off If the unit has not yet been switched on, press the REC/STOP button to switch the unit on. Press the MENU multifunction button twice and choose whether you want to or buttons. When the VOS switch the function on or off by means of the mode is switched on, the VOS indicator will appear in the display. Press the MENU multifunction button down in the middle once and the display will return to normal. You can start the next recording immediately while a recording is being made. The present recording will be this, press the multifunction button stopped and the next recording will be started immediately under a new number. Hold the PAUSE button pressed for two seconds during a recording. Now select the required message using the The number of the note will be shown in the display. The note can be played back by pressing the PLAY/STOP button. You can interrupt the playback with the PAUSE button and then continue with the PAUSE or PLAY/STOP button. The volume can be adjusted in 20 steps by means of the VOL. During playback: or If you want to fast forward or fast rewind within a long note, hold the multifunction button pressed until you reach the required position. While you are listening to a note, you can switch automatically to the previous (rewind) or or next note. To do this, simply press the multifunction buttons (forward) briefly. If you want to search for a particular note, you can use the SCAN function. With this function, only the first 5 seconds of the note are played back in each case before changing automatically to the next note. To do this, press the PLAY/STOP button for two seconds. The SCAN function always starts from the currently selected note number. When you have found the right message, press the PLAY/STOP button again to listen to this note in full. First select the note that you want to delete. If, however, you want to cancel the erase procedure, wait until the ERAS message goes off. Hold down the ERASE button and then the REC/STOP button. [. . . ] in the case of complaint , we reserve the right to repair or replace defective parts or to exchange the equipment. Exchanged parts or exchanged equipment become our property. Claims for compensation are excluded insofar as they do not relate to criminal intent or gross negligence on the part of the manufacturer. All guarantee claims according to these conditions must be raised exclusively with your dealer. [. . . ]