User manual AUDIOLINE WAVE 10X ECO

[. . . ] Always keep a cord connected telephone which operates without an external power supply available in case of emergency situations. Attention: Never use the telephone in the vicinity of medical equipment. effects on such equipment cannot be fully ruled out. DECT1 telephones can cause an unpleasant humming sound in hearing aids. [. . . ] Ringing volume for external calls y/z, EXT RING VOL , ®, y/z, VOLUME OFF to VOLUME 5 , ®. Ringing volume for internal calls y/z, INT RING VOL , ®, y/z, VOLUME OFF to VOLUME 5 , ®. Ringing melody for external calls y/z, EXT MELODY , ®, y/z, MELODY 1 to MELODY 5 , ®. Ringing melody for internal calls y/z, INT MELODY , ®, y/z, MELODY 1 to MELODY 5 , ®. Take a call (off-hook) End a call (on-hook) Make an external call Redial the number Dial from calls log Dial from phone number memory , ë or ë, £, y/z, or , £ y/z, ´, y/z, Internal calls 12 Making an internal call There must be two or more handsets registered on the base station in order to make internal calls. Forwarding external calls internally / Conference calls After the internal party has answered, transfer the call by pressing the button. To start a conference call, wait for the party called to answer the internal call and then press the # button. If the handset called does not answer, take the external call back by pressing and release the I button. Function Switch the handset on /off Key lock on Key lock off Receiver volume Ringing melody volume Muting/Activating microphone in handset Locate handset (paging) Button sequence 5 sec R 3 sec * *, * , y/z y/z while phone is ringing during the call on the base station After muting the microphone, the caller can no longer hear you. The duration of a call is displayed in hours, minutes and seconds during the call. If your handset is not registered on the base station, icons flash in the display. To register the handset, press the button on the base station for five seconds and then proceed as follows: ®, y/z, REGISTER , ®, REG BASE , ®, BASE 1 2 3 4 . To register a handset from a different manufacturer, refer to the operating manual supplied with the respective handset. the four-digit PIN for your base station is 0000. Up to four handsets can be registered on your base station. However, you can only activate your handset on one base station at a time. Up to 30 phone numbers can be stored in the phonebook. Each entry can be customised with its own individual ringtone (5 melodies). When the memory capacity is completely full, an existing entry must be overwritten. A total of 30 phone numbers are stored in a call log. The caller number display function is an optional service offered by telephone network providers. If this service is not offered, the incoming calls are not displayed. [. . . ] All deficiencies related to material or manufacturing errors within the period of guarantee will be redressed free of charge. Rights to claims under the terms of guarantee are annulled following tampering by the purchaser or third parties. Damage caused as the result of improper handling or operation, incorrect positioning or storage, improper connection or installation or Acts of God and other external influences are excluded from the terms of guarantee. In the case of complaints, we reserve the right to repair defect parts, replace them or replace the entire device. [. . . ]