User manual AUDIOTRONICS 154S2

[. . . ] Use proper safety gear and tools for the installations procedure to prevent personal injury or damage to the plasma display or plasma mount. The floor or tabletop must be capable of supporting at least five (5) times the weight of plasma display. If not, the floor or tabletop must be reinforced. [. . . ] Proper installation procedure by qualified personnel as outlined in the installations instructions must be adhered to. Failure to do so could result in serious personal injury The entire installation instructions should be fully read and understood, including all of the safety symbols and safety precautions before beginning installation. The installation instructions should be read, understood and followed to prevent personal injury or property damage. Keep these installation instructions in an easily accessible location for future reference. Indicates that the power plug is to be disconnected from the power outlet. Safety precautions must be taken at all times. Contact Sony for any questions Warning and caution in general Do not install near heater, fireplace, direct sunlight or air conditioning or any other source of direct heat energy. Failure to do so may result in damage to the plasma display and could cause a risk of fire. At least two qualified people should always perform the installation work. On the 42" and 50" two (2) M5 x 12 Phillip screws (security screws) can be used for additional security. NOTE: If using a 32" plasma, secure it with the two (2) M6 x 30 Phillip screws supplied. NOTE: Two (2) security screws for the 42" and 50" plasma displays. Check all hardware for proper tightness and security. M5 x 12 phillips screws M6 x 30 phillips screws NOTE: Security screws for the 32" plasma displays. Check all hardware for proper tightness and security. -5- (Optional) fixed installation Step 1 Invert the stand and locate the two (2) mounting points on the bottom of the stand for (optional) fixed tabletop installation. Measure the distance between center to center of these two (2) holes and mark the table. See figure 4. NOTE: This diagram shows the bottom of the stand. Wood screw access holes Step 2 OPTIONAL TABLE MOUNTING If securing to a wood table, mark the table and drill properly. Secure the stand with the two (2) #10 x 1-1/4" wood screws (supplied). [. . . ] See figure 4. NOTE: This diagram shows the bottom of the stand. Wood screw access holes Step 2 OPTIONAL TABLE MOUNTING If securing to a wood table, mark the table and drill properly. Secure the stand with the two (2) #10 x 1-1/4" wood screws (supplied). [. . . ]