User manual AUDIOVOX 1286384

[. . . ] MANUAL OWNER'S MANUAL ACD-94 AM/FM/MPX RADIO WITH FOLD-DOWN DETACHABLE FRONT PANEL, COMPACT DISC PLAYER, CD CHANGER CONTROLS, MP3 CD PLAYBACK, WIRELESS REMOTE CONTROL AND QUARTZ CLOCK INSTRUC INSTALL ALLA INSTRUCT INSTALL INSTALL AT IONINSTRUCT T IONS ALLA INSTALL AT ION INSTRUCT IONS INSTALLATION INSTRUCTIONS This unit is designed for installation in cars, trucks, and vans with an existing radio opening. In many cases, a special installation kit will be required to mount the radio to the dashboard. These kits are available at electronics supply stores and car stereo specialist shops. Always check the kit application before purchasing to make sure the kit works with your vehicle. [. . . ] Make sure there is no dust or dirt on the electrical terminals on the back of the panel as this could cause intermittent operation or other malfunctions. THEFT DETERRENT LED (30) RESET BUTTON (31) DISC SLOT (19) MOUNTING PLATE GUIDE (2 PLACES) PANEL MOUNTING PLATE CD EJECT BUTTON (27) FRONT PANEL SETT SET T ING THE CLOCK 1. Switch the vehicle ignition and radio "on". Press the Time/Frequency (T/F) button to call the time display. Within 10 seconds, press and hold the T/F button until a single beep sounds and the time display flashes. With the display flashing, press the Up MANU/SKIP ( ) button to adjust the hours and A/P indication, or the Down MANU/SKIP ( ) button to adjust the minutes to the correct time. Five seconds after the last hour or minute adjustment is made, the time will be set in the unit and the display will return to the normal indication. PLA ERROR CD PL AYER ERROR CODES If a problem should develop while operating the CD player, an error code (ER-1, ER-2, ER-3, etc. ) may appear on the display panel. This can indicate a number of problems with the unit, including a mechanical error or an error in the microprocessor control of the player. If an error code should appear, try ejecting and re-loading the disc into the player. While the disc is out of the unit, make sure it is clean, undamaged, and loaded correctly (label surface up). You may also try activating the RESET button on the unit, but this will also erase the time and pre-set memories. If the suggested measures do not solve the problem, contact an approved warranty station near you for further assistance. 12 dm SPECIFICAT IONS SPECIFICAT SPECIFICAT IONS SPECIFICAT IONS SPECIFICATIONS Size: Operating Voltage: Fuse Ratings: Output Power: Output Wiring: 7" W x 2" H x 6-5/16" D 178 mm x 50 mm x 160 mm 12 volts DC, negative ground Constant (Yellow wire): 15 AMP. 160 watts maximum (40 watts x 4 channels) Floating-ground type designed for 4 speaker use. Front and rear channels CANNOT be combined (bridged) for use with 2 speakers. RCA low-level outputs (front and rear channels). +0/-3 dB >65 dB >60 dB 0. 2% Output Impedance: Low-Level Output: Tuning Range: Sensitivity: FM Stereo Separation: CD Frequency Response: CD Signal/Noise Ratio: CD Channel Separation: CD Distortion: *Specifications are subject to change without notice. CD-R AND CD-RW PLAYBACK CAPABILITY This model can play most CD-R and CD-RW media that contains audio programs. Playback of both CD-R and CD-RW depends on the conditions of the recording equipment and the CD-R or CD-RW disc quality. In some cases, a CD-R or CD-RW disc cannot be played on this unit. 13 CHA CONTROL OLS CD CH A NGER CONTROLS CD CH A NGER CONTROLS CHA CONTROL OLS Built into this radio are controls to operate an optional CD changer. Please check with your Rampage/Audiovox car stereo specialist or call 1-800-645-4994 for recommendations of the models that will work with this radio. Adjustment of the audio functions (volume, tone, balance, and fader) for the CD changer operate in the same manner as they do for radio play. The following controls will operate the CD changer when it is installed and connected to this radio. Refer to the owner's manual included with the CD changer for instructions on the installation and correct loading and use of the CD magazine. ds CUE/REVIEWFUNCTIONS ( / ) higher track number will be selected as shown on the display panel. [. . . ] Should this occur, the player will not operate properly until the moisture has evaporated. The unit is designed with a vibration dampening CD mechanism to minimize interruption of disc play due to normal vibration in a moving vehicle. When driving on very rough roads, however, occasional sound skips may occur. This will not scratch or damage the disc and normal play will resume when the rough conditions cease. HANDLING COMPACT DISCS Dirt, dust, scratches, and warpage can cause skips in the playback and deterioration of sound quality. [. . . ]