User manual AUDIOVOX 1287729

[. . . ] Locate suitable location near the vehicles rear license plate to route the camera cable. The camera cable can be routed through an existing grommet or use a location where a 5/8" hole can be drilled. [. . . ] Using the black screws provide, tighten the screws with the anti-theft tool provided. Pull gently on the camera cable to remove slack. 3. 4. 128-7729 4 of 8 If using Audiovox LCD rearview mirror or LCM45NB, use the extension cable supplied with the monitor. Connect the Camera cable to the extension cable (supplied). Route the extension cable up to the intended monitor. Black wire- connect to chassis ground b. Red wire- connect to 12V accessory wire c. Red RCA- connect to audio input (if equipped) When the connection of the Camera and Extension Cable is outside of the vehicle, (such as a Pickup Truck Application), prior to making the connection, coat the male and female terminals with the Dielectric grease supplied. Slide the packaged pre-sized heat shrink tube over both connectors and shrink using a heat gun to ensure a watertight connection. View angle adjustment: This camera frame is designed for universal application. The angle of the image of the installed frame might have to be adjusted depending on the license plate mounting angle. There is a 10degree angle adjustment wedge supplied to change the downward angle from 40 degrees to either 30 or 50 degrees. [. . . ] Low Lux Sensitivity :0. 2 Lux S/N Ratio : More than 48db. Operating Temperature: -13o F to 158o F (-25o C to 70o C) 11. [. . . ]