User manual AUDIOVOX ACC-40

[. . . ] To remedy the situation, remove the discs from the unit and wait approximately one hour. During this time the moisture will evaporate and the unit will operate normally. INTERRUPTIONS IN SOUND (Skipping) The sound from the unit may "skip" and be interrupted if the antivibration springs are not set correctly, if the changer is mounted in excess of a 15° angle, or when travelling on very rough road surfaces. If this should occur, check for errors made during installation or wait for the road surface to improve. [. . . ] 4 6 CMAT OPC To assure proper playback, it is recommended that the CD magazine be loaded with more than one disc. When it becomes necessary to reset the changer circuitry following system installation, or due to a changer error code, the reset button (Figure 5) may be pressed to reinitialize the micro process circuitry and resume normal changer operation. Fig. 5 l 6 C MA T O PC Eject Button Reset Button 4 OPERATING INSTRUCTIONS This CD Changer is designed to operate through the FM stereo section of your existing car radio. The adjustment of volume, balance, tone and other audio functions is made by using the controls on the car stereo, whereas control of disc play is accomplished by the CD Changer Commander wired control, which can be mounted at a convenient place on the dashboard. The output signal from the CD changer can be either 89. 1 or 88. 7 MHz (set by the installer) on the FM band. It is recommended that a pre-set memory pushbutton on the radio be set to the output frequency of the changer to simplify operation of the system. Consult the operating instructions of the car stereo for directions on setting the memory pre-set buttons. The LCD panel on the control unit will illuminate and play of disc #1, or the disc that was previously playing, will begin. Adjust the volume, balance and tone to your taste by using the controls on the car stereo. When the last track on the disc has been played, the unit will automatically advance to and begin play of the next disc. When the last track on disc #6 has been played, the unit will automatically return to disc #1 and begin play again. 7 1 9 3 4 SETTING UP FOR OPERATION Following the instructions in the "USE OF THE CD MAGAZINE" section of this manual, load the desired number (up to 6) of 5" (12cm) compact discs into the CD magazine and insert the magazine into the changer. DO NOT USE 3" (8cm) CD SINGLES, EITHER WITH OR WITHOUT AN ADAPTER, IN THIS CHANGER. DAMAGE TO THE CHANGER AND/OR DISC MAY OCCUR AND SUCH DAMAGE WILL NOT BE COVERED BY THE WARRANTY ON THIS PRODUCT. Turn on the car stereo and select FM band operation. Tune the radio to either 88. 7 or 89. 1 MHz. (depending on the frequency to which the installer has set the changer system) or push the pre-set button that has been set as per the above description. Turn the changer on by pressing the POWER button on the 8 2 5 6 10 2 5 1 LIQUID CRYSTAL DISPLAY PANEL 2 PLAY/PAUSE SELECTOR ( The Liquid Crystal Display (LCD) panel will illuminate when the CD changer is operating and will display the disc and track numbers as well as various function symbols as described in the following sections. 5 TRACK SELECT BUTTONS (T-UP/T-DN) 6 TRACK SEARCH BUTTON The Track Select function is used to quickly access the beginning of a particular track. Press the Forward Track Select (T-UP) or Backward Track Select (T-DN) button to locate the desired track as shown by the TRACK number on the display panel. II ) Pressing this button turns on the CD changer, illuminates the LCD panel and begins play of disc #1 if a new CD magazine has been loaded into the changer. If a magazine was already in the changer, play will resume from the track on the disc previously in play. Play of the disc is shown by the rotating disc symbol ( ) on the LCD panel. Pressing the button again will temporarily stop play of the disc. The Pause indication (PAUSE) will be shown flashing on the LCD panel and the disc symbol will stop rotating and also flash. [. . . ] THE EXTENT OF THE COMPANY'S LIABILITY UNDER THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT PROVIDED ABOVE AND, IN NO EVENT, SHALL THE COMPANY'S LIABILITY EXCEED THE PURCHASE PRICE PAID BY PURCHASER FOR THE PRODUCT. This Warranty is in lieu of all other express warranties or liabilities. ANY IMPLIED WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY, SHALL BE LIMITED TO THE DURATION OF THIS WRITTEN WARRANTY. ANY ACTION FOR BREACH OF ANY WARRANTY HEREUNDER INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY MUST BE BROUGHT WITHIN A PERIOD OF 30 MONTHS FROM DATE OF ORIGINAL PURCHASE. [. . . ]