User manual AUDIOVOX APS-905

[. . . ] Model APS-905 Owner's Manual FEATURES : 3 Channel Remote Car Starter w 1 Five Button One way Flashlight Programmable RF Transmitters w 1 Five Button Programmable Dot Matrix Transceiver w Three Channel Transceiver (capable of accepting 4 transmitters) w Keyless Entry Outputs (+) and (-) w On-Board Start Relay w On-Board Accessory Relay w On-Board Ignition 1 Relay w On-Board Ignition 2 Relay w On-Board Ignition 3 Relay w Ignition 2 & 3 Relay Selectable On or Off During Cranking w On-Board Parking Light Relay w Turbo Run Timer Capable w Ignition 3 / Shock By-Pass / GM VAT Output (relay required) w Tach Signal Learning Circuit w Two ( + ) and Two ( - ) Safety Shutdown Circuits w Alarm By-Pass Output w Accessory Outputs (Pulse Before & After Start, During Crank & After Shut Down) w Selectable Steady or Flashing Parking Lights for Run Indication w Selectable 5, 10, 15, 20 Minute Run Time w Selectable 1 Sec. , 3. 5 Sec. , or 1 Sec. /Dbl 1 Sec. Door Lock Output Pulse w Telematic Port For Upgradable Modules w Data Port For Audiovox Specific IDB Interface Modules 1 128-7409 1 of 8 KEYLESS ENTRY 1. The Lock button on the transmitter is used to lock the vehicle's doors, the Unlock button is used to unlock the vehicle's doors. To lock or unlock the doors simply press and release the desired function button one time. [. . . ] Page Call Out: (only available on certain models) From within the vehicle, if the valet push button is pressed for three seconds, the alarm unit in the vehicle will transmit to the LCD remote and a beep tone will be heard and a phone icon on the hand held transmitter will flash indicating that someone is calling you to the vehicle. Your transmitter has a battery indicator that is shown in the upper right corner of the screen as shown below. This icon indicates a new battery shown with 3 bars. As the battery deteriorates, the bars will disappear. 1 bar indicates the battery should be replaced. Replace battery with a fresh 1. 5V AAA battery and dispose of the used battery properly. Other icons that will be displayed at times when certain functions and features are active in the vehicle or on the remote: Range Indicator. The range indicator will have bars to the side of the icon if the unit is out of range. Vibrate Mode On, this icon will be displayed if you select vibrate instead of tones. Locate vibrate/tone select in the transmitter program section and set for vibrate. This icon will be toggled on and off when the "F" + Trunk/Key buttons are pressed simultaneously. The feature must be set in the feature selection menu of the transmitter. 4 128-7409 4 of 8 Count Down Timer . This icon is toggled on and off by pressing the "F" + Option buttons simultaneously. The feature must be set for a time in the feature selection menu of the transmitter. The transmitter has a built in timer that can count down from 10, 20, 30, 60, 90, or 120 minutes. This feature is useful when parking the vehicle in a metered parking lot. If the time on the parking meter is 30 minutes, you can set the count down timer to 20 minutes. The transmitter will emit a beep tone when the timer expires to remind you to get back to your vehicle. To use the parking meter timer, Press the "F" + Option buttons more than one time. Once activated the Count Down Timer as described above. Activating the "F" + Option a second time will set the parking meter count down to 10 minutes, a third time will set it to 20 minutes, a fourth time will set it to 30 minutes, etc. . . [. . . ] The vehicle will start one time automatically when the temperture reaches 0*. Caution, Be certain vehicle is outside before activating this mode. To toggle this feature on of off, from the Locked/Armed mode, press the Option and Lock buttons simultaneously. (Available on certain remote start models only). [. . . ]