User manual AUDIOVOX DST961

[. . . ] =~ dJ . ~ DST 900 MHz 961 DIGITAL CORDLESSTELEPHONE IMPOR1ANT: REVIEW INSTRUCTIONS BEFORE OPERATION + '""' ~ Lb INTRODUCTION Parts Check List 1. Wall mount accessory To purchase replacement battery packs, call AUDIOVOX Communications at 1-800229-1235, in N. Y. This equipment complies with Parts 15 and 68 of the Federal Communications Commission (FCC) rules for the United ~"Q ~r. :bo;t U"i. ~~. :. -~ ~ ~IIM~6~O'y . ~ltQ'y ~~ -3:- ~~ ~ ~ States. It also complies with regulations -RSS-21 O and CS-03 of Industry Canada (IC). [. . . ] The telephone line cord has a snap-in plug at each end. Insert one of the plugs into the jack on the bottom of the base. Insert the other end of the plug into the wall jack. Plug the AC adaptor into an electrical outlet and the DC connector on the back of the Base Unit. 1. Position the wall mount bracket on the base. Une up the tabs on the wall mount adaptor with the holes on the bottom of the base. Snap the wall mount bracke~ firmly in place. Position the base so the mounting studs will fit -~ I-F ~ -k -. :. -J IJ ~ BASIC ANSWERING CALLS When the Handset is in the Base Unit cradle, simply pick up the Handset to answer an incoming call. OPERATION HOLD Press HOLD to place an active call on hok1. LED will flash to indicate When the Handset is away from the Base Unit press any key other than OFF, MUTE or the Volume keys to answer an incoming call. MAKING CALLS t Press the TALK key and wait for a dial tone. Press HOLD again to return to the call. MUTE Press MUTE to disable the handset microphone. The MUTE/LOW BATT LED will stay on continuously. Press MUTE again to return to two-way conversation. If you make a mistake when dialing, press OFF to hang up, then press the TALK key to get the dial tone again. DISCONNECTING To end a call, either place the handset back in the Base Unit, or press OFF . EXTENSION IN USE INDICATOR Press MUTE during incoming ringing to disable the ringer for the duration of the call. To cancel the page, either press PAGE again on the base or press OFF on the handset. ADVANCED FUNCTIONS TONE TEMPORARY When another phone is in use on the same line, and the Audiovox DST961 is in standby mode, the TALK LED will flash slowly. Extension In Use indication will not function when the Handset is out of range. VOLUME CONTROLS The volume controls for the handset are located on the side of the unit. Press the< or > keys to increase or decrease the volume. Holding either key down will continually change the volume setting. [. . . ] If there is no dial tone on that phone either, the problem is in your wiring or local service. YOU GET NOISE, STATIC, OR A WEAK SIGNAL EVEN WHEN YOU E NEAR . THE BASE UNIT. Household appliances plugged into the same circuit as the base unit can sometimes cause interference. 'yulJ GET NOISE, STATIC, OR A WEAK SIGNAL WHEN YOU E AWAY FROM THe BASE UNIT. [. . . ]