User manual AUDIOVOX FDK606A

[. . . ] Burn Up To 1500 MP3 and WMA Files onto a DVD+R /RW · Heat Management System - Forced Air Cooling to keep the chip sets operating at nominal temperatures · Subject to technical changes " Before accessing any navigation features, you must purchase and install the NAV module. all installation and operating instructions will be included with the NAV navigation module. Once the NAV is connected and operating properly, the NAV source mode will become active. While the NAV is not installed, the NAV option appears gray, indicating the function is not available. [. . . ] Subject to technical changes Subject to technical changes Touch for quick access to Equalizer level settings 9. Touch to view the SOURCE MENU and select a new playback source 18. MEM: View screen used to enter current channel into preset memory 19. 1/2 or 2/2: Touch this page button to view a second page of on-screen buttons 20. PS (Preview Scan): Touch to scan all stations available, stopping for 5 seconds at each and continuing until a station is selected 22. When a PTY category is selected from the touch screen menu, the radio will start scanning for the selected category. Touch the top left corner of the screen (the RADIO circle) to view the SOURCE MENU. Touch the BAND button (15) on the screen, or press the BAND button on the unit (4) or remote control (20) to change between the following bands: FM1, FM2, FM3, AM1, and AM2 NOTE: The BAND button on the unit only works when the TFT is closed. Direct Tuning To enter a radio station directly, touch the Enter the desired radio station using the on-screen numberpad. press the enter button (arrow) to tune to the selected station. To exit the screen without changing the station, touch Exit. Keep pressing and releasing the button to increase the rate from "2X" to "4X", "8X", and "20X". Press >/|| (18) on the remote control or touch the onscreen play button (>) to resume normal play. Keep pressing and releasing the button to increase the rate from "2X" to "4X", "8X", and "20X". Press >/|| (18) on the remote control or touch the onscreen play button (>) to resume normal play. VCD (PBC Off): Repeat Single, Repeat Off button on screen to alter repeat mode according to the NOTE: For VCD play, the repeat function is not available if PBC is on. Use the A-B function to define a specific area of a disc to repeat. Press the RPT A-B button again once you reach the desired end point (B) of the repeated section. Press the RPT A-B button again to cancel the A-B section setting and stop repeat play. NOTE: When a VCD is playing with PBC turned "On", activating random playback automatically turns PBC off. With a DVD, VCD, or CD playing, press the RDM button (33) on the remote control to activate random playback and play all chapters/tracks in random order. Press the >>| button (19) on the remote control to play the next random track. [. . . ] Also, use folders when burning large numbers of songs / files to a disc for easy music navigation. Subject to technical changes GENERAL Unit will not power on Radio Fuse blown Car battery fuse blown Illegal operation Install new fuse with correct rating Install new fuse with correct rating Press the RESET button located in the bottom right corner of the front panel Replace battery with new one Remove battery and install correctly Check wiring and correct Increase volume level Review wiring diagram and check "MUTE" connection Replace speakers Adjust the channel balance to the center position Insulate all speaker wiring connections Use original copy Connect proper speakers Check speaker contact Check that the "MUTE" connection is not grounded and that it's properly insulated Check wiring and correct Battery depleted Battery installed incorrectly Improper audio output connection Volume set too low Improper "MUTE" connection Speakers damaged Heavily biased volume balance Speaker wiring is in contact with metal part of car Pirated disc is in use Speaker power rating not compatible with unit Speaker is shorted "MUTE" wire is grounded Incorrect connection between ACC and positive battery wire Tel-Mute malfunction Unit resets itself when engine is off TFT Auto Open is turned off Incorrect connection to parking brake wire PRK SW is activated, parking brake is not engaged Turn TFT Auto Open on Check wiring and correct Stop vehicle in safe place and apply parking brake DVD is not compatible with current TV system settings Change setup to accommodate disc Improper video signal connections Check wiring and correct Use correct aspect ratio setting Press OPEN key to restart monitor movement Monitor stops at incorrect position Moving path is blocked TUNER Weak station searching Auto antenna is not fully extended Auto antenna not properly connected LOCAL function is activated Disc is warped or scratched Disc is dirty or wet Laser pickup is dirty Incompatible disc is used Disc rating exceeds Parental Lock rating limit Disc region code is not compatible with unit Disc is inserted upside down Subject to technical changes Connect the auto antenna control cable properly Connect the auto antenna control cable properly Turn LOCAL function Disc does not play back Use disc in good condition Clean disc with soft cloth Clean laser pickup with cleaning disc Use compatible disc Change Parental Lock settings to lower restriction Use disc with proper region code Image blurred, distorted, or dark PCB cannot be used during No repeat or searching MP3 Interruption occurred during playback Use original disc PCB is not available on the disc PCB is on Turn PCB off Clean disc or replace Recreate disc with good files Message is longer than LCD can display Disc is being read Disc is dirty Disc is upside down Disc not present in loading compartment Disc is dirty Disc is upside down Disc format is not compatible with this unit DVD is not compatible with region code of unit Illegal mechanism operation Clean disc with soft cloth Insert disc with label side up Insert disc Clean disc with soft cloth Insert disc with label side up Press EJECT key for 5 seconds to reset loading mechanism Subject to technical changes Use only a clean silicone cloth and neutral detergent to clean the front panel or monitor. A rough cloth and nonneutral detergent (such as alcohol) may result in scratching or discoloration. If the temperature inside the player gets too hot, a protective circuit automatically stops play of the disc. [. . . ]