User manual AUDIOVOX FPE1705

[. . . ] The console is constructed to provide years of enjoyment. Standardized design and manufacture ensures reliability and longevity. Please read the following instructions thoroughly for correct installation and proper operation. Store this manual in a convenient and safe place for future reference. [. . . ] Under the vehicle place 1 sealing washer (rubber side towards vehicle floor) and 1 large fender washer over each of the bolts and attach the nuts. In addition to the sealing washer it may be desirable to place a small circle of silicon sealer around the hole under the vehicle before installing the washers and nut. This will further prevent moisture from getting into the vehicle. Have a second person inside the vehicle hold the bolts securely with a box-end wrench while the person underneath the vehicle tightens down the nuts securely. 5 E. Unit View (Refer to Figure 2 and Figure 3) OPTIONAL CONNECTIONS Figure 2 24 12 Vdc ANT FM MOD Figure 3 6 RADIO 1. Headphone Input Jack #1* *NOTE: Mutes Internal Speakers 13. Power Supply Connection (Refer to Figure 3) 1. Open the access panel on the bottom rear of the unit by pressing the latch located on the left side of the panel toward the center of the console and pulling outward. Plug one end of the cigarette lighter adapter into the DC input jack in the rear of the console. Replace the access panel and have the power cord pass through either hole at the bottom of the panel. Plug the other end into the cigarette lighter receptacle in the vehicle. 7 G. Press A-B to set the ending point B and the player will repeat edly play the part between Point A and Point B. 12 c. Press A-B the 3rd time to cancel the A-B repeat playing and resume normal playback from Point A. 5). During playback press REPEAT to repeat the current chapter. b. During playback press REPEAT again to repeat the current title. 13 c. During playback press REPEAT the 3rd time to cancel the repeat play and resume normal playback. The repeat display will disappear automatically in about 3 seconds. 4. Setup (The contents vary from disc-to-disc. ) Press SETUP to display the main page of the setup menu on the screen. Press SETUP again to quit and the unit will resume play back. 1). Highlight GENERAL SETUP using to enter to the general setup menu. , then press ENTER 14 A. Highlight TV DISPLAY using then use the to button enter the TV DISPLAY submenu. Highlight the desired TV display mode and press ENTER to confirm the setting. [. . . ] When SKIP mode is off, the TV will stop on all active channels. Press (TV) DISPLAY to illuminate the on-screen display for TV channel number. Press SLEEP to set the remaining playing time. 20 J. Playing a Video Game (Refer to Figure 2) Plug the video output from your game system into the yellow video jack and the Audio L and Audio R into the applicable jacks on the front of the unit. [. . . ]