User manual AUDIOVOX LCM7020PKG

[. . . ] 4) The monitors will show all of the functions including the FM selection (Master Only) with the comprehensive OSD. 5) The LCM7020PKG System supplies two IR Headphone sets (Audiovox IR2CHS). The headsets have an A-B switch that allows the user's to select the audio from either the Master (CH A) or the Slave (CH B). 6) Using different IR codes, the Master Monitor will only respond to the Master Remote Control unit and the Slave monitor will respond only to the Slave Remote Control unit. [. . . ] Hold the LCM7020PKG Headrest above the seat and insert the two cables into the headrest support tube holes. Make sure that the headrest is in the correct position (Display facing the rear). Route the cables through the seat back and out the bottom of the seat. Place the Headrest support tubes into the support tube holes while pulling the cables to remove the slack. Be sure to leave enough slack in the monitor cables to allow the headrest to move up or down. Slide a few inches of each cable through the Black Shrink Sleeve (see 2) f. Carefully remove Clear Shrink Tubing making sure not to damage wires inside. (see 1) g. Separate and straighten all of the wires. Carefully insert each of the Terminal Pins into the Terminal Connector making sure that each color wire is placed into the matching color connector hole. Slide the Black Shrink Sleeve down over the wires and apply heat (hot air). 9) Connect all the components together (electrically) and verify that the proper operation of all the system functions. NOTE: This is best done BEFORE the components are permanently mounted. 10) After verifying the proper operation of the system, proceed to mount each component. 11) When all the components are mounted, re-check the entire system to be sure it is functioning correctly. Make sure that no wiring was pinched, or connected improperly during the final installation. -3- CABLE TERMINAL INSTALLATION Master & Slave Monitor 3 4 2 SHRINK SLEEVES -4- LCM7020PKG SYSTEM WIRING DIAGRAM POWER ST OP/EJECT A UTO RE EA PT SE NSOR REW PLA Y F FW D 1. ) Make sure the Master, and Slave monitor have been installed properly, as described in the procedures as stated on page 3. 2. ) Connect the four JST terminals of the System Main Cable to the corresponding JST terminals of Master Monitor and Slave monitor on the bottom of the seats. Label the JST terminal of System Main Cable Master and connect them to the Master monitor. The other JST terminal of System Main cable should be labeled as Slave and conneced to the Slave monitor. [. . . ] VOLUME+ : Increase the volume of the Wired Headphones with VOLUME+ button. Also, with the menu displayed on the screen you may then use the VOLUME- and VOLUME+ buttons to select from: Picture, Source, Audio (Master only) and Display off. When the appropriate item is highlighted you may then press the MENU button to access that function, then use the VOLUME- or VOLUME+ to adjust or switch the selected item. OSD 1) Press the MENU button (on Master monitor) or MENU/ENTER button (on the master remote control) , the following OSD is displayed: a) For using the Master monitor: MENU PICTURE SOURCE AUDIO DISPLAY OFF Use VOLUME- or VOLUME+ buttons to highlight the AUDIO item, then press MENU/ENTER button, OSD as below : AUDIO AUDIO 1 AUDIO 2 Use VOLUME- or VOLUME+ buttons to select the audio for the FM Modulator. [. . . ]