User manual AUDIOVOX TV32

[. . . ] The TERK logo is a trademark of the TERK Technologies Corp. Small Directional UHF only HDTV Antenna Pro T0278-TV32-. qxp 7/11/03 04:20 PM Page C2 Safety Precautions Safety Precautions (continued) TV32 TV32 WARNING READ ALL OF THE ATTACHED SAFETY INSTRUCTIONS BEFORE PROCEEDING WITH ANTENNA AND/OR MAST ASSEMBLY AND INSTALLATION. INSTALLATION OF THIS ANTENNA NEAR POWER LINES IS DANGEROUS. FOR YOUR SAFETY, FOLLOW THE INSTALLATION INSTRUCTIONS. Use extreme caution when installing or removing an outdoor antenna that is located close to overhead wires such as power lines, telephone lines or cable TV lines. [. . . ] You will probably need a helper to view the TV set while you are rotating the antenna. Secure the coaxial downlead to the mast (using cable ties) to prevent it from whipping by the wind. Ground the antenna and mast per the accompanying grounding instructions. (See page 13. ) 3 4 T0278-TV32-. qxp 7/11/03 04:20 PM Page C6 Antenna Assembly (continued) General Installation Instructions for Mast Mounted Antennas TV32 TV32 Elements Boom Point Towards TV Stations Downlead Connection Mast Clamps 1. Assemble your antenna on the ground at the installation site per the instructions. On the ground, attach the antenna to the mast. Pull enough coax downlead and connect to the antenna per its instructions. To insure that the mast does not fall, a durable nonconductive rope should be attached to each ten foot section as it is raised. If you are using guy wire installation (not included) instead of a mounting bracket: · Install guy anchor bolts. · Estimate length of guy wire and cut. · Attach to mast using a guy ring. Carefully take the antenna and mast assembly to the mounting bracket and insert. In case of a guyed installation, it will be necessary to have at least a second person hold the mast upright while the guy wires are attached and tightened to the anchor bolts. NOTE: Point the antenna towards the station broadcast tower ­ look at a neighbor's outdoor antenna for help in locating the direction of the tower. Rotate the TV32 antenna until you receive the best picture. You will probably need a helper to view the TV set while you are rotating the antenna. 5 Mast 6 T0278-TV32-. qxp 7/11/03 04:20 PM Page C8 Where To Install Your Antenna Types of Support Structures and Mounting TV32 TV32 Before attempting to install your antenna, decide on the best location to install your antenna for both safety and performance. To determine a safe distance from wires, power lines and trees: 1. Measure the length of your antenna and multiply by 2. Add this measurement to the length of your tower/mast. If you are unable to maintain this safe distance, STOP!Most antennas are supported by tripod masts or pipe masts attached to the chimney, roof, or to the side of the house. Generally, the higher the antenna, the better it performs. [. . . ] Use at least three guy wires for each ten foot section of mast. Make sure guy wires are spaced evenly apart. Antenna Removal Removal of the antenna should be exactly the reverse of the installation instructions. Please, for your own safety, follow the instructions for installing the antenna starting with the last step first. An attic installation is the easiest, fastest and most convenient type of antenna installation, especially if you do not have easy or secure access to an outdoor area. [. . . ]