User manual AUDIOVOX VCCYL35N

[. . . ] The following tips will help you determine the best location for mounting the unit: · Select a location that does not interfere with the normal functions of the driver and will not cause injury to the driver or a passenger in the event of a sudden stop or other emergency. Do not install the unit in a location that would subject it to high temperatures (such as in direct sunlight or next to a heating unit), dust, dirt or excessive vibration. install the unit in a horizontal position if at all possible. If the installation angle exceeds 30 degrees from the horizontal, the unit may not function optimally. [. . . ] Press DIS again to return to the default display. The DIS button is also used to set the clock to the correct time. With the clock displayed, press and hold DIS for more than three seconds to enter into clock set mode. When the hours flash on the display, rotate the volume control (clockwise or counter-clockwise) to adjust the hours. When finished, press DIS again, and the minutes begin flashing. rotate the volume control (clockwise or counter-clockwise) to adjust the minutes. Press DIS again to store the time, or the unit will store it automatically after five seconds have elapsed since the last adjustment. Press AUX (9) to enter auxiliary mode when an audio source is connected to the unit through the AUX IN cable on the back panel. Use a ballpoint pen or other thin metal object to press the reset button (10) under the following circumstances: after the completion of initial installation/wiring, if none of the function buttons work or if an error symbol appears in the display. To restore all factory settings, enter tuner mode, then press and hold MOD until "EEP INIT" appears in the display. Press BND (11) to change between three FM bands and two AM bands. To select the desired disc for play, press CAT/DISC up (22a) to advance to a higher disc or CAT/DISC down (22b) to return to a lower disc. The number of the disc in play will appear on the display. Pause, Track Select, Repeat, Intro Scan and Random Shuffle features during CDC operation are accessed using the same methods as for regular disc play. Attempting to use non-standard shape discs may damage the unit. Do not stick paper, tape or any other substance to either side of the CD, as it may cause the disc to malfunction. Protect CD's from dirt, dust, scratches and warping, as these may cause malfunction. This unit cannot play a CD-R or CD-RW that is not finalized. refer to the manual for the CD-R/CD-RW recorder or software for information on the finalization process. Depending on the recording status, recording equipment and disc conditions, some CD-R and CD-RW discs may not play on this unit. For optimal performance, use CD-R discs with speeds 1x to 8x with write speed 1x to 2x. Use CD-RW discs with speeds 1x to 4x with write speed 1x to 2x. [. . . ] Cameras AV2 and AV3 are configured to be switched on or off from the triggers, allowing these inputs to be used for side cameras operating off the turn signal voltage. Press NAV (32) to directly access the Navigation AV source (AV4), which is only to be used with the Audiovox NPD5500 navigation computer (sold separately). Audio from this source will be heard from the speaker on the back of the monitor screen. Press SCREEN ANGLE momentarily ("Monitor Angle" will flash in the diplay when this feature is activated), and adjust the angle of the monitor to one of five positions by pressing CAMERA TILT "-" (34a) or "+" (34b). [. . . ]