User manual AUDIOVOX VE560 Operation Manual

[. . . ] ® ELECTRONICS CORP. VE-560 Low Profile Television 5. 6" LCD Drop Down Under Counter TV OPEN TIME SET F G TIME ADJUST SENSOR POWER ® ELECTRO NI CS CO RP . F TV/AV1/AV2 AUTO PROG PICTURE VOLUME G TV CHANNEL Installation and Operation Manual FEATURES n n n n n Multi-function Remote Control Automatic Channel Programming Cable Ready 125 Channel Tuner Internal Stereo Speakers Wall or Under Cabinet Mounting F o r C u s tom e r S e rv ic e V is it O u r W e b s ite A t 999. audiovox. com P ro d u c t In fo rm a tio n , P h o to s , FA Q 's O w n e r 's M a n u als 128-6317 NOTE: This Page Left Blank Intentionally IMPORTANT SAFETY INFORMATION A. Precautions 1) Unplug the unit before cleaning. Do not use liquid cleaners or aerosol cleaners. 2) Use only Audiovox approved accessories. [. . . ] You can press TV/AV1/AV2 to select the audio and video source. EXTERNAL TV ANTENNA JACK You can input your CATV into this jack for receiving CATV stations. F. Press TV/AV1/AV2 to select the TV mode or AV1/AV2. Press TV/CATV to select the type of signal you receive, When using an antenna, adjust it to its best extension, angulation and direction to optimize the image and sound. When using cable, connect the cable to the external antenna jack, and press TV/CATV on the remote control to select STD, HRC or IRC (see Remote Control section). STD is used by most cable systems, however, if the STD setting does not work with your TV, try the other settings and/or check with your cable service provider. Pressing AUTO PROG, the TV's tuner will scan the entire range of the selected band and memorize all the active channels in your area. Press TV CHANNEL UP/DOWN or use the number buttons for TV to select any active channel. Press VOLUME UP/DOWN to raise or lower the sound level. If the picture needs to be adjusted, press PICTURE to illuminate the onscreen display for contrast, brightness, color and tint in sequence, and press +/- to adjust each function up/down. Press MUTE to cut off the sound, and the screen will display the volume adjustment bar for six seconds to indicate that the sound has been turned off. Press MUTE again to restore sound to the sound level set previously. You can also release the mute feature by pressing VOLUME UP/DOWN. 5 G. Connect the power to the unit, the LCD in the front panel will display the time. Press the TIME SET button once (the hour will start to blink) press TIME ADJUST up/down direction buttons to adjust the hour, press TIME SET again (the minute will start to blink) press TIME ADJUST up/down direction buttons to adjust the minute. When the correct time is entered, press TIME SET again to set time. H. Remote Control The remote control will operate Audiovox Televisions and Video Cassette Players. It is not a universal remote control and will not control equipment from other manufacturers. If a universal remote control is to be used with the VE-560, choose the remote encoding scheme for Audiovox Televisions when programming the remote. TV/VIDEO Press this button to select the TV mode or AV1/AV2. POWER ON/OFF Press this button to turn on the TV. The channel number or current video source will be displayed on screen, and the picture will appear in a few seconds. [. . . ] To ERASE a channel, press the ERASE/WRITE button on the Remote Control Unit until "MANUAL MEMORY XX ERASE" is displayed on screen. To STORE a channel, press the button until "MANUAL MEMORY XX ADD" is displayed on screen. 9 L. Specification System: Screen Size: Illumination: Bachlighting Life Expectancy: Resolution: Pixel Configuration: Remote Control: Antenna: TV Channel: (CATV) Audio Output: Power Supply: Power Consumption: Operating Humidity: Operating Temperature: Storage Temperature: NTSC 5. 6 Inches Edge Light Tube 10, 000 Hrs. RGB Stripe Infrared Rays Telescopic Antenna, External Antenna Jack 2-6 (VLF Band), 7-13 (VHF Band), 21-69 (VHF Band), 1-125 2 x 1. 5W/80ohm(MAX) 13. 5V/1. 5A 14W 10-75% 41-140 Degrees Fahrenheit (5-40) Centigrade 4-140 Degrees Fahrenheit (-20-60) Centigrade 10 128-6317 TROUBLESHOOTING Problem Poor Reception Solution Verify Tuner setting matches Antenna / Cable broadcast system. [. . . ]