User manual AUSTRALIAN MONITOR ACM250P

[. . . ] This switching on and switching off is quite normal. The "Protect" function is there to protect the amplifier from a high temperature problems which would only occur if the fan stopped working or became clogged up. In this very rare occurance, the protect LED will illuminate and the amplifier may shut down. The amplifier will automatically restart once it's internal temperature has fallen within "safe" limits. [. . . ] When signal is connected to one XLR, the other XLR becomes a line level output allowing the input signal to be distributed (split) to other amplifiers. In some projects, the same input may be looped through to multiple amplifiers using this method. Up to 6 amplifiers can be looped together without any noticeable loss in level. A distribution amplifier should be used when more than 6 amplifiers need to be looped. The XLR's are wired as follows: Pin 1: Shield. Pin 3: Cold, -, Negative Fuse Sizes Mains 240 VAC - 6 Amperes Slow Blow DC - 2 x 10 Amperes Slow Blow Important Safety Information 1. Save the carton and packing material even if the equipment has arrived in good condition. Should you ever need to ship the unit, use only the original factory packing. Read all documentation before operating your equipment. Retain all documentation for future reference. Follow all instructions printed on unit chassis for proper operation. Do not spill water or other liquids into or on the unit, or operate the unit while standing in liquid. Make sure power outlets conform to the power requirements listed on the back of the unit. Do not use the unit if the electrical power cord is frayed or broken. The power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords and plugs, convenience receptacles, and the point where they exit from the appliance. Always operate the unit with the AC ground wire connected to the electrical system ground. Precautions should be taken so that the means of grounding of a piece of equipment is not defeated. Mains voltage must be correct and the same as that printed on the rear of the unit. Damage caused by connection to improper AC voltage is not covered by any warranty. Have gain controls on amplifiers turned down during power-up to prevent speaker damage if there are high signal levels at the inputs. Power down & disconnect units from mains voltage before making connections. Never hold a power switch in the "ON" position if it won't stay there itself! [. . . ] The equipment has been exposed to rain D. The equipment does not appear to operate normally, or exhibits a marked change in performance E. The equipment has been dropped, or the enclosure damaged. Engineered by Audio Telex Communications Pty Ltd, Sydney, Australia A. B. N. 78 001 345 482 Inc in NSW www. audiotelex. com. au Export Sales & Corporate Head Office Private Bag 149, Silverwater NSW 1811 149 Beaconsfield Street, Silverwater NSW 2128 Australia Ph: 61-2- 9647 1411 Fax: 61-2-9748 2537 E-mail: ho@audiotelex. com. au Sydney (NSW & ACT Sales) Private Bag 149, Silverwater NSW 1811 149 Beaconsfield Street, Silverwater NSW 2128 Ph: (02) 9647 1411 Fax: (02) 9648 3698 E-mail: nsw@audiotelex. com. au Adelaide (SA & NT Sales) P. O. [. . . ]