Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual AUSTRALIAN MONITOR ATC5488. We hope that this AUSTRALIAN MONITOR ATC5488 user guide will be useful to you.
Lastmanuals help download the user guide AUSTRALIAN MONITOR ATC5488.
Manual abstract: user guide AUSTRALIAN MONITOR ATC5488
Detailed instructions for use are in the User's Guide.
[. . . ] ATC5488, Tone Generator Module Installation Instructions
Thank you for choosing an Australian Monitor Installation Series ATC5488 tone generator module. [. . . ] For installation into an IC30 amplifier: Locate the empty 7 pin `end' connector receptacle on the mixer PCB to the left of the heat sink when looking from the front panel. Connect the module to this receptacle, ensuring that the orange wire on the connector is at the right hand end of the connector receptable. For installation into an SA series amplifier: Locate the empty 7 pin `end' connector receptacle on the mixer PCB between the Ch 6 pot and the bass pot. Connect the module to this receptacle, ensuring that the orange wire on the connector is at the right hand end of the connector receptable when viewed from the front panel For installation into a TX6000 or TX8000 mixer: Locate the empty 7 pin `end' connector receptacle behind the Ch 5 pot on the mixer PCB. Connect the module to this receptacle, ensuring that the orange wire on the connector is at the right hand end of the connector receptable when viewed from the front panel. The ATC5488 module is supplied with double sided adhesive enabling the module to be permanently attached to the chassis or under the lid of your mixer or amplifier. On selected mixers and amplifiers, spare screw terminals on the rear panel provide a facility where the activation wires from the ATC5488 can be connected to the back panel for easy external connection to switches or a timer.
Connections
Connection to amplifier: Orange - Output Black - Ground Blue - Mute switch to 1 Red - DC Supply (Min. 18VDC) Connections to activate tones: Black - Common White - Evacuation tone Yellow - Bell Tone Purple - Alert Tone Blue - Pre Announce Chime NOTE: Note that the trim pot located in position R10 on the ATC5488 module attenuates the level out of the ATC5488 and works in an anti-clockwise fashion ie, turning it fully clockwise will completely attenuate the signal output whilst turning it fully anti-clockwise will allow full signal though to the amplifier stage.
Engineered by Audio Telex Communications Pty Ltd, Sydney, Australia
A. B. N. [. . . ] Box 512, Albany 1331 Unit B, 11 Piermark Drive, Albany 1331 Ph: (09) 415 9426 Fax: (09) 415 9894 E-mail: audiotlx@nznet. gen. nz [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE AUSTRALIAN MONITOR ATC5488
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual AUSTRALIAN MONITOR ATC5488 will begin.
